Electrochemical corrosion behaviour of rolled dual phase Mg-8Li-graphene composite
- 1 September 2023
- journal article
- research article
- Published by IOP Publishing in Surface Topography: Metrology and Properties
- Vol. 11 (3) , 035017
Abstract
In this research, the effect of interrupted rolling on electrochemical corrosion behaviour of Mg-8Li-xGr composite is investigated. Graphene reinforced composite was developed by using stir casting route and rolled with different reductions in thickness of 50, 75 and 90%. Investigation on potentiodynamic polarization of rolled composite depicts that increase in reduction percentage increases the corrosion rate of the developed composite. Electrochemical impedance studies reveal that composite reduced at 50% thickness exhibits higher charge transfer resistance of 80 Ωcm2. Nyquist plot depicts occurrence of inductance loop that reveals occurrence of oxide layer breakage. Addition of graphene up to 0.4 wt% increase the corrosion resistance and further addition exhibits adverse effect in corrosion behaviour due to the galvanic effects. The occurrence of pitting corrosion is evidenced from corrosion surface morphology.Keywords
Funding Information
- DST- SERB- TARE (TAR/2019/000092)
This publication has 29 references indexed in Scilit:
- A comprehensive review on graphene-based anti-corrosive coatingsChemical Engineering Journal, 2019
- Effect of aluminium on microstructure, mechanical property and texture evolution of dual phase Mg-8Li alloy in different processing conditionsArchives of Civil and Mechanical Engineering, 2018
- Effect of Aluminum Addition on the Evolution of Microstructure, Crystallographic Texture and Mechanical Properties of Single Phase Hexagonal Close Packed Mg-Li AlloysJournal of Materials Engineering and Performance, 2018
- Composition and microstructure dependent corrosion behaviour of Mg-Li alloysElectrochimica Acta, 2018
- The effects of homogenization treatment on wear resistance of AZ61 magnesium alloy fabricated by extrusion-shear processApplied Physics A, 2017
- Effect of rolling-induced microstructure on corrosion behaviour of an as-extruded Mg-5Li-1Al alloy sheetCorrosion Science, 2017
- Influences of die channel angles on microstructures and wear behaviors of AZ61 wrought magnesium alloy fabricated by extrusion-shear processApplied Physics A, 2016
- Study on the microstructural evolution of AZ31 magnesium alloy in a vertical twin-roll casting processApplied Physics A, 2016
- Enhanced tensile properties of magnesium composites reinforced with graphene nanoplateletsMaterials Science and Engineering: A, 2015
- Susceptibility of rare-earth-magnesium alloys to micro-galvanic corrosionCorrosion Science, 2010