Sinnaeruvadi Kumaran
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Sinnaeruvadi Kumaran has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
K. Veera Venkata Nagaraju
Green Energy Materials and Manufacturing Research Group,Department of Metallurgical and Materials Engineering, National Institute of Technology Tiruchirappalli, Tamil Nadu, India
3 shared publications- Krishnaveni Ulaganathan
Green Energy Materials and Manufacturing Research Group, Department of Metallurgical and Materials Engineering, National Institute of Technology, Tiruchirappalli, Tiruchirappalli, India
3 shared publications - N. Sriraman
National Institute of Technology
3 shared publications P. Vignesh
Green Energy Materials and Manufacturing Research Group, Department of Metallurgical and Materials Engineering, National Institute of Technology, Tiruchirappalli 620015, India
3 shared publications- Porselvan Vivekanandhan
Green Energy Materials and Manufacturing Research Group, Department of Metallurgical and Materials Engineering, National Institute of Technology, Tiruchirappalli, 620015, Tamil Nadu, India
3 shared publications T. Srinivasa Rao
Green Energy Materials and Manufacturing Research Group,Department of Metallurgical and Materials Engineering, National Institute of Technology Tiruchirappalli, Tamil Nadu, India
3 shared publications
Latest Publications
- 10 May 2024
- Published by Springer Nature in Applied Physics A
- Vol. 130 (6) , 1-8
Tuning p-type semiconduction with ultra-low thermal conductivity in nanocrystalline n-type BiSbTe1. 5Se1.5 high entropy alloy via Ag doping
- 10 May 2024
- Published by Springer Nature in Applied Physics A
- Vol. 130 (6) , 1-8
Tuning p-type semiconduction with ultra-low thermal conductivity in nanocrystalline n-type BiSbTe1. 5Se1.5 high entropy alloy via Ag doping
- 1 September 2023
- Published by IOP Publishing in Surface Topography: Metrology and Properties
- Vol. 11 (3) , 035017
Electrochemical corrosion behaviour of rolled dual phase Mg-8Li-graphene composite
In this research, the effect of interrupted rolling on electrochemical corrosion behaviour of Mg-8Li-xGr composite is investigated. Graphene reinforced composite was developed by using stir casting route and rolled with different reductions in thickness of 50, 75 and 90%. Investigation on potentiodynamic polarization of rolled composite depicts that increase in reduction percentage increases the corrosion rate of the developed composite. Electrochemical impedance studies reveal that composite reduced at 50% thickness exhibits higher charge transfer resistance of 80 Ωcm2. Nyquist plot depicts occurrence of inductance loop that reveals occurrence of oxide layer breakage. Addition of graphene up to 0.4 wt% increase the corrosion resistance and further addition exhibits adverse effect in corrosion behaviour due to the galvanic effects. The occurrence of pitting corrosion is evidenced from corrosion surface morphology.
- 1 September 2023
- Published by IOP Publishing in Surface Topography: Metrology and Properties
- Vol. 11 (3) , 035017
Electrochemical corrosion behaviour of rolled dual phase Mg-8Li-graphene composite
In this research, the effect of interrupted rolling on electrochemical corrosion behaviour of Mg-8Li-xGr composite is investigated. Graphene reinforced composite was developed by using stir casting route and rolled with different reductions in thickness of 50, 75 and 90%. Investigation on potentiodynamic polarization of rolled composite depicts that increase in reduction percentage increases the corrosion rate of the developed composite. Electrochemical impedance studies reveal that composite reduced at 50% thickness exhibits higher charge transfer resistance of 80 Ωcm2. Nyquist plot depicts occurrence of inductance loop that reveals occurrence of oxide layer breakage. Addition of graphene up to 0.4 wt% increase the corrosion resistance and further addition exhibits adverse effect in corrosion behaviour due to the galvanic effects. The occurrence of pitting corrosion is evidenced from corrosion surface morphology.
- 3 April 2023
- Published by Springer Nature in JOM
- Vol. 75 (7) , 2338-2350
Metallurgical and Bio-corrosion Attributes of Thermo-mechanically Processed α-Magnesium-Lithium Alloy for Bio-implant Application
- 3 April 2023
- Published by Springer Nature in JOM
- Vol. 75 (7) , 2338-2350
Metallurgical and Bio-corrosion Attributes of Thermo-mechanically Processed α-Magnesium-Lithium Alloy for Bio-implant Application
- 30 March 2023
- Published by Springer Nature in Electronic Materials Letters
- Vol. 19 (6) , 534-542
Enhancement in Power Factor of Al-Doped Cu2Se Thermoelectric Compound Prepared by Combustion Synthesis via Spark Plasma Sintering Technique
- 30 March 2023
- Published by Springer Nature in Electronic Materials Letters
- Vol. 19 (6) , 534-542
Enhancement in Power Factor of Al-Doped Cu2Se Thermoelectric Compound Prepared by Combustion Synthesis via Spark Plasma Sintering Technique
- 9 January 2023
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 52 (3) , 2168-2176
Thermoelectric Properties of Cu2Se Compound Fabricated at Low-Temperature Combustion Synthesis as a New Approach with Alternative Techniques
- 9 January 2023
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 52 (3) , 2168-2176
Thermoelectric Properties of Cu2Se Compound Fabricated at Low-Temperature Combustion Synthesis as a New Approach with Alternative Techniques
- 7 January 2023
- Published by Springer Nature in Metals and Materials International
- Vol. 29 (7) , 2093-2108
In-vitro Cytotoxicity Assessment of Mg-4Li-3Sn (LT43) Alloy with Structure-Property Correlation for Bio-Medical Applications
- 7 January 2023
- Published by Springer Nature in Metals and Materials International
- Vol. 29 (7) , 2093-2108
In-vitro Cytotoxicity Assessment of Mg-4Li-3Sn (LT43) Alloy with Structure-Property Correlation for Bio-Medical Applications
- 5 December 2022
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 32 (17) , 7756-7765
Evaluating the Microstructural, Mechanical, and Electrochemical Behavior of Spark Plasma-Assisted Dissimilar Joining of 17-4 PH Stainless Steel to Inconel 718
- 5 December 2022
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 32 (17) , 7756-7765
Evaluating the Microstructural, Mechanical, and Electrochemical Behavior of Spark Plasma-Assisted Dissimilar Joining of 17-4 PH Stainless Steel to Inconel 718
- 28 October 2022
- Published by Springer Nature in Transactions of the Indian Institute of Metals
- Vol. 76 (4) , 937-944
Phase Evolution Mechanism of Cu2Se Compound During Mechanical Milling and Spark Plasma Sintering Process
- 28 October 2022
- Published by Springer Nature in Transactions of the Indian Institute of Metals
- Vol. 76 (4) , 937-944
Phase Evolution Mechanism of Cu2Se Compound During Mechanical Milling and Spark Plasma Sintering Process
- 4 August 2022
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 290
Texture-governed electrochemical behaviour of cross rolled Mg-5Al-5Sn (AT55) magnesium alloy
- 4 August 2022
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 290
Texture-governed electrochemical behaviour of cross rolled Mg-5Al-5Sn (AT55) magnesium alloy