Study of the Cylinder Deactivation on Tribological Parameters and Emissions in an Internal Combustion Engine
Open Access
- 7 April 2022
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 10 (4) , 60
Abstract
In the present investigation, a study is carried out using numerical simulation on the effects of cylinder deactivation on tribological parameters and emissions in an internal combustion engine. For the development of the research, a tribological model was used to predict the characteristics of the lubrication film, friction conditions, blow-by gas, and deformation of the piston rings. Additionally, the construction of a CFD model was carried out to describe the kinematic movement of the engine piston. The analysis of results allowed for the demonstration of the active cylinders presenting an increase of 21.53% and 7.65% in the pressure and temperature in the cylinder wall. Additionally, the active cylinders present a reduction of 11.33% in the minimum thickness of the lubrication film and an increase in the friction force due to asperities, which implies an increase of 33% in power losses due to friction. The implementation of technologies such as cylinder deactivation causes an increase in combustion gas leaks caused by the increase in pressure of the active cylinders. However, the use of this technology allows reducing 9.09%, 8.26%, and 7.41% in CO, HC, and NO emissions. Although the use of technologies such as cylinder deactivation allows significant fuel savings, it is necessary to consider the negative effects caused by this technology, such as the increase in combustion gas leaks and the increase in power loss by the greatest frictional forces.Keywords
This publication has 41 references indexed in Scilit:
- Direct measurement of piston friction of internal-combustion engines using the floating-liner principleProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2013
- Transient elastohydrodynamic lubrication of rough new or worn piston compression ring conjunction with an out-of-round cylinder boreProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2012
- A study of combustion, instantaneous heat transfer, and emissions in a spark ignition engine during warm-upProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2008
- Integrated Tribological Analysis within a Multi- physics Approach to System Dynamics2005
- Dynamic behaviours of piston rings and their practical impact. Part 2: Oil transport, friction and wear of ring/liner interface and the effects of piston and ring dynamicsProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2002
- Review of Power Cylinder Friction for Diesel EnginesJournal of Engineering for Gas Turbines and Power, 2000
- New Results of Traction Force Calculations in Elastohydrodynamic ContactsJournal of Tribology, 1985
- An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic LubricationJournal of Lubrication Technology, 1978
- The Contact of Two Nominally Flat Rough SurfacesProceedings of the Institution of Mechanical Engineers, 1970
- A Numerical Solution to the Elasto-Hydrodynamic ProblemJournal of Mechanical Engineering Science, 1959