Failure Analysis of Mortar Specimens with a Hexagonal Honeycomb Panel during Fatigue Load
Open Access
- 26 February 2025
- journal article
- Published by Periodica Polytechnica Budapest University of Technology and Economics in Periodica Polytechnica Civil Engineering
- Vol. 69 (2) , 611-620
Abstract
It has been published in recent research studies that several mechanical properties of mortar reinforced with suitably spatial shaped plastic elements can be improved. Thus, a hexagonal geometric shape was chosen due to its high rigidity for this study. Stress distribution at a bi-material interface between a polymer part reinforcing a mortar specimen and the rest of the mortar part has been investigated to explain fatigue fracture behavior of rectangular specimens tested. A three-point-bending (3PB) test was simulated via a finite element method (FEM) considering several simplifications, and various heights of the polymer reinforcement were modeled to investigate its influence on stress redistribution. For comparison, a pure mortar specimen without any plastic elements was considered the reference. The numerical results obtained are discussed and compared to the experimental ones. Within the experimental campaign, bulk density, static properties and fatigue characteristics were tested, analyzed and discussed. Improvements in flexural strength were observed when the plastic panel was used as reinforcement, which agrees with other scientific works. Directions for future research were identified.Keywords
This publication has 33 references indexed in Scilit:
- Mechanical properties of mortar beams reinforced by gyroid 3D printed plastic spatial elementsCement and Concrete Composites, 2022
- Cementitious composites reinforced with 3D printed functionally graded polymeric lattice structures: Experiments and modellingAdditive Manufacturing, 2021
- Properties of concrete elements with 3-D printed formworks which substitute steel reinforcementConstruction and Building Materials, 2019
- Recycled polyethylene terephthalate as a new FFF feedstock materialAdditive Manufacturing, 2018
- Cell geometry effect on in-plane energy absorption of periodic honeycomb structuresThe International Journal of Advanced Manufacturing Technology, 2017
- About the Use of Recycled or Biodegradable Filaments for Sustainability of 3D Printing2017
- Mesh‐Mould: Robotically Fabricated Spatial Meshes as Reinforced Concrete FormworkArchitectural Design, 2014
- Optimization of fibre reinforcement for waste aggregate cement compositeConstruction and Building Materials, 2013
- Median diameter as a grading characteristic for fine aggregate cement composite designingConstruction and Building Materials, 2012
- A fracture model for fiber reinforced cementitious materialsCement and Concrete Research, 1973