A One-Dimensional Computational Model to Identify Operating Conditions and Cathode Flow Channel Dimensions for a Proton Exchange Membrane Fuel Cell
Open Access
- 10 September 2024
- Vol. 5 (3) , 624-643
Abstract
A one-dimensional computational model has been developed that can be used to identify operating conditions for the cathode side of a proton exchange membrane fuel cell such that both the inlet and outlet relative humidity is equal to 100%. By balancing the calculated pressure drop along the cathode side flow channel with the change in molar composition, inlet conditions for the cathode side can be identified with the goal of avoiding channel flooding. The channel length, height, width and the land-to-channel width ratio are input parameters for the model so that it might be used to dimension the cathode flow field. The model can be used to calculate the limiting current density, and we are presenting unprecedented high values as a result of the high pressure drop along the flow channels. Such high current densities can ultimately result in a fuel cell power density beyond the typical value of 1.0–2.0 W/cm2 for automotive fuel cells.Keywords
This publication has 31 references indexed in Scilit:
- Chapter 5: Fuel Cell Mass Transport2016
- The dew point temperature as a criterion for optimizing the operating conditions of proton exchange membrane fuel cellsInternational Journal of Hydrogen Energy, 2012
- Low stoichiometry operation of a proton exchange membrane fuel cell employing the interdigitated flow field – A modeling studyInternational Journal of Hydrogen Energy, 2012
- Design of an optical thermal sensor for proton exchange membrane fuel cell temperature measurement using phosphor thermometryJournal of Power Sources, 2010
- Simultaneous measurement of current and temperature distributions in a proton exchange membrane fuel cellJournal of Power Sources, 2010
- A study of multi-phase flow through the cathode side of an interdigitated flow field using a multi-fluid modelJournal of Power Sources, 2010
- Measurement of through-plane effective thermal conductivity and contact resistance in PEM fuel cell diffusion mediaElectrochimica Acta, 2010
- Effects of flow field and diffusion layer properties on water accumulation in a PEM fuel cellInternational Journal of Hydrogen Energy, 2007
- Capillary pressure and hydrophilic porosity in gas diffusion layers for polymer electrolyte fuel cellsJournal of Power Sources, 2006
- In situ diagnostic of two-phase flow phenomena in polymer electrolyte fuel cells by neutron imagingElectrochimica Acta, 2006