Generalization of the Transient DC-Bias Current Elimination Scheme in Dual Active Bridge Converters Using the Real-Time Zero Current Crossing Prediction Algorithm
- 29 September 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Transportation Electrification
- Vol. 12 (1) , 374-391
Abstract
The dual active bridge (DAB) is a power electronic converter widely used in areas such as transportation, renewable energy sources, and battery-based energy storage systems. This type of converter typically serves as an interface between voltage sources, providing galvanic isolation while operating under varying transferred power. As a result, transient dc-bias current may arise, leading to increased losses and potentially causing saturation of magnetic components. Typically, to overcome the aforementioned negative effects, proper converter control is utilized. One recently proposed method for eliminating dc-bias current is based on the idea of shifting the voltage waveforms in phase so that the current waveforms, at the beginning of the switching cycle, start from zero. This approach enables a seamless power transition. However, the aforementioned method has been implemented only for the specific modes of triple-phase shift (TPS) modulation. Another aspect is the dead-time effect, for which compensation has not been shown in a straightforward manner. Given the above, the algorithm called real-time zero current crossing prediction (RT-ZCCP) is proposed to augment the known solution with an arbitrary modulation scheme compatibility, along with a simple dead-time compensation technique. This article outlines the RT-ZCCP algorithm in a step-by-step manner, including the detailed analysis of the dead-time effect, and proposes an optimal method to choose the corrective time value. The circuit-parameter-dependent robustness analysis of the proposed algorithm has also been performed. The RT-ZCCP algorithm was implemented on the TMS320F28379D microcontroller and has been successfully verified on the 1.3-kW laboratory prototype with SiC-based MOSFET modules, operating at a switching frequency of 40 kHz. What is more, the experimental results comparison with the other competitive methods has been performed to prove the effectiveness of the proposed RT-ZCCP algorithm.Keywords
Funding Information
- National Centre for Research and Development, Poland, through the Strategic Research and Development Program “New Technologies in the Field of Energy” (NTE-I/0035/2021-00)
- “APStorage 2.0: Modular, Configurable, Remote-Controlled, and Cybersecure System for Energy Storage and Conditioning.”
This publication has 32 references indexed in Scilit:
- DC Bias Elimination in Isolated DC-DC Converters using Fundamental-Frequency Ripple2025
- Dual active bridge converter with photovoltaic arrays for DC microgrids: design and analysisIET Conference Proceedings, 2023
- A Unified Optimal Modulation Strategy for DAB Converters to Tradeoff the Backflow Power Reduction and All ZVS in the Full Operating RangeIEEE Journal of Emerging and Selected Topics in Power Electronics, 2023
- A Comprehensive Optimization Strategy of DAB Converter With Minimal Current Stress and Full Soft Switching in the Whole Operating RangeIEEE Journal of Emerging and Selected Topics in Power Electronics, 2023
- Review of Electric Vehicle Charging Technologies, Standards, Architectures, and Converter ConfigurationsIEEE Access, 2023
- Application of Bidirectional Dual-Active Bridge Converter on EVs Fast Charging System2023
- A Comprehensive Review of Power Converter Topologies and Control Methods for Electric Vehicle Fast Charging ApplicationsIEEE Access, 2022
- Loss Imbalance and Transient DC-Bias Mitigation in Dual-Active-Bridge DC/DC ConvertersIEEE Journal of Emerging and Selected Topics in Power Electronics, 2020
- Dynamic control of a dual active bridge for bidirectional AC charging2015
- Comprehensive steady state analysis of bidirectional dual active bridge DC/DC converter using triple phase shift control2014