Microstrain and Residual Stress in Thin-Films Made from Silver Nanoparticles Deposited by Inkjet-Printing Technology
Open Access
- 1 August 2014
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 996, 930-935
Abstract
Colloidal suspensions of nanoparticles are increasingly employed in the fabrication process of electronic devices using inkjet-printing technology and a consecutive thermal treatment. The evolution of internal stresses during the conversion of silver nanoparticle-based ink into a metallic thin-film by a thermal sintering process has been investigated by in-situ XRD using the sin2ψ method. Despite the CTE mismatch at the film/substrate interface, the residual stress in silver films (below 70 MPa) remains lower than in conventional PVD thin-films, as a result of the remaining porosity. A Warren-Averbach analysis further showed that the crystallite growth is associated with a minimization of the twin fault density and the elastic microstrain energy above 150°C. A stabilization of the microstructure and internal stress is observed above 300°C. Inkjet-printing technology thus appears as a good alternative to conventional metallization techniques and offers significant opportunities asset for interconnect and electronic packaging.Keywords
This publication has 21 references indexed in Scilit:
- Thickness Effect on Microstructure and Residual Stress of Annealed Copper Thin FilmsMaterials Science Forum, 2011
- Utilizing inkjet printing to fabricate electrical interconnections in a system-in-packageMicroelectronic Engineering, 2010
- Characterization of direct patterned Ag circuits for RF applicationMicroelectronic Engineering, 2010
- High Lateral Resolution Analysis Of Stresses In Silver Thin Films By Means Of Raman MicroscopyAIP Conference Proceedings, 2010
- Size Effect on the Thermodynamic Properties of Silver NanoparticlesThe Journal of Physical Chemistry C, 2008
- Size matters: why nanomaterials are differentChemical Society Reviews, 2006
- Large Area Electronics Using Printing MethodsProceedings of the IEEE, 2005
- Residual stress analysis of thin films and coatings through XRD2 experimentsThin Solid Films, 2004
- A heating stage up to 1173 K for X-ray diffraction studies in the whole orientation spaceJournal of Applied Crystallography, 2003
- Fine-line conductor manufacturing using drop-on demand PZT printing technologyIEEE Transactions on Electronics Packaging Manufacturing, 2002