Pressure Cycle Testing of Cr–Mo Steel Pressure Vessels Subjected to Gaseous Hydrogen
- 25 August 2015
- journal article
- Published by ASME International in Journal of Pressure Vessel Technology
- Vol. 138 (1) , 011401
Abstract
Pressure cycle tests were performed on two types of Cr–Mo steel pressure vessels with notches machined on their inside under hydrogen-gas pressures, between 0.6 and 45 MPa at room temperature. Fatigue crack growth (FCG) and fracture toughness tests of the Cr–Mo steels samples from the vessels were also carried out in gaseous hydrogen. The Cr–Mo steels showed accelerated FCG rates in gaseous hydrogen compared to ambient air. The fracture toughness of the Cr–Mo steels in gaseous hydrogen was significantly smaller than that in ambient air. Four pressure vessels were tested with gaseous hydrogen. All pressure vessels failed by leak-before-break (LBB). The LBB failure of one pressure vessel could not be estimated by using the fracture toughness in gaseous hydrogen KIC,H; accordingly, the LBB assessment based on KIC,H is conservative and there is a possibility that KIC,H does not provide a reasonable assessment of LBB. In contrast, the fatigue lives of all pressure vessels could be estimated by using the accelerated FCG rates in gaseous hydrogen.Keywords
This publication has 24 references indexed in Scilit:
- Effect of Displacement Velocity on Elastic Plastic Fracture Toughness of SM490B Carbon Steel Plate in 0.7 MPa Hydrogen GasTRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 2013
- Effect of Loading Rate and Tempering Temperature on Fracture Toughness of Hydrogen-Charged Low Alloy Steel SCM440TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 2011
- Hydrogen enhanced crack propagation of SCM440H low-alloy steel under long-term varying loadEngineering Fracture Mechanics, 2010
- Effects of Hydrogen on Fatigue Crack Growth and Stretch Zone of 0.08mass%C Low Carbon Steel PipeTRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 2008
- Effect of Hydrogen and Frequency on Fatigue Behavior of SCM435 Steel for Storage Cylinder of Hydrogen StationTRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 2007
- Effect of Hydrogen on the Tensile Properties of 900-MPa-Class JIS-SCM435 Low-Alloy-Steel for Use in Storage Cylinder of Hydrogen StationJournal of the Japan Institute of Metals and Materials, 2006
- Hydrogen-assisted Cracking2003
- Hydrogen-enhanced localized plasticity—a mechanism for hydrogen-related fractureMaterials Science and Engineering: A, 1994
- The effect of sheet thickness on near-threshold fatigue crack propagation and oxide- and roughness-induced crack closure.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 1986
- A study on the fatigue crack growth in 9% Ni steel plate: Growth rate of surface crack in a plate under arbitrarily combined tension and bendingEngineering Fracture Mechanics, 1975