Numerical simulation to evaluate the influence of geometric parameters on the physical behavior of heat exchangers
Open Access
- 1 December 2021
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 2139 (1) , 012006
Abstract
In the present investigation, a methodology was developed by means of numerical simulation for the evaluation of the influence of the geometric parameters of the heat exchangers used in thermoelectric generation devices. The validation of the proposed methodology was carried out through experimental tests on a diesel engine test bench under four load conditions (2 Nm, 4 Nm, 6 Nm, and 8 Nm) and a constant speed of 3600 rpm. The results obtained show that the methodology proposed by means of the numerical simulation presents a high concordance with the behavior described experimentally. The deviation between the simulation predictions and the experimental results was less than 4%. Additionally, it was evidenced that the change in the geometry of the heat exchanger has a considerable impact on the parameters of heat flow and surface temperature. It was shown that a 50% reduction in fin distance causes an increase of 2% and 2.4% in the previous parameters. Through geometric modifications, the electrical power generated increased by 7.9%. In general, the methodology developed through numerical simulation allows the analysis of the physical, thermal, and hydraulic phenomena present in heat exchangers focused on use in thermoelectric devices.Keywords
This publication has 16 references indexed in Scilit:
- Characterization of the Performance of Centrifugal Pumps Powered by a Diesel Engine in Dredging ApplicationsInternational Review of Mechanical Engineering (IREME), 2019
- Optimization of a thermoelectric generator for heavy-duty vehiclesEnergy Conversion and Management, 2019
- A review of the development and applications of thermoelectric microgenerators for energy harvestingRenewable and Sustainable Energy Reviews, 2018
- Performance comparison of single- and multi-stage onboard thermoelectric generators and stage number optimization at a large temperature differenceApplied Thermal Engineering, 2018
- Modeling of a hybrid electric heavy duty vehicle to assess energy recovery using a thermoelectric generatorEnergy, 2018
- Energy harvesting performance of hexagonal shaped thermoelectric generator for passenger vehicle applications: An experimental approachEnergy Conversion and Management, 2018
- Analysis of the fins geometry of a hot-side heat exchanger on the performance parameters of a thermoelectric generation systemApplied Thermal Engineering, 2017
- Optimization of finned-tube heat exchangers for diesel exhaust waste heat recovery using CFD and CCD techniquesInternational Communications in Heat and Mass Transfer, 2014
- Technologies to recover exhaust heat from internal combustion enginesRenewable and Sustainable Energy Reviews, 2012
- Numerical Modelling of the Turbulent Flow Developing Within and Over a 3-D Building Array, Part I: A High-Resolution Reynolds-Averaged Navier—Stokes ApproachBoundary-Layer Meteorology, 2004