Multi-plate interceptive electron beam energy diagnostic—Implementation and validation
Open Access
- 1 December 2018
- journal article
- conference paper
- Published by AIP Publishing in AIP Advances
- Vol. 8 (12) , 125117
Abstract
A previous publication [P. D. McChesney, “Multi-plate interceptive electron beam energy diagnostic—Theoretical design,” AIP Adv. (submitted)] reported a new interceptive electron beam kinetic energy measurement technique based on the beam penetration depth within a stack of conductive plates and gave results on the theoretical design of such a device. This paper expands on this and gives further results on the actual implementation of the diagnostic. The device geometry and measurement electronics system are described in detail. A prototype version of the multi-plate diagnostic was fabricated and tested using an electron linear accelerator at the Idaho Accelerator Center (IAC). A high-precision magnetic spectrometer system was designed and built for the purpose of validating the multi-plate diagnostic’s energy measurement capabilities. It was found that the diagnostic provides electron beam energy estimates that are accurate to better than the 10% level.Keywords
Funding Information
- Air Force Research Laboratory (FA9451-13-C-0218)
This publication has 6 references indexed in Scilit:
- Propagation of modulated electron and X-ray beams through matter and interactions with radio-frequency structuresJournal of Applied Physics, 2018
- Initial MCNP6 Release OverviewNuclear Technology, 2012
- Measurements of prompt radiation induced conductivity of Kapton.2010
- ITS Version 6 : the integrated TIGER series of coupled electron/photon Monte Carlo transport codes.2008
- Measurement of Radiation Induced Conductivity for Hardened Cable Dielectric Materials at High FluenceIEEE Transactions on Nuclear Science, 1983
- X-Ray-Induced Photoconductivity in Dielectric FilmsIEEE Transactions on Nuclear Science, 1972