Jon Stoner
Research Subjects
Jon Stoner has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Brian Berls
Idaho Accelerator Center, Idaho State University 2 , Pocatello, Idaho 83201, USA
2 shared publicationsChad O’nEill
Idaho Accelerator Center, Idaho State University 2 , Pocatello, Idaho 83201, USA
2 shared publicationsKevin Folkman
Idaho Accelerator Center, Idaho State University 2 , Pocatello, Idaho 83201, USA
2 shared publicationsAri Foley
Idaho National Laboratory, 1765 N. Yellowstone Hwy, Idaho Falls, ID, 83415. USA
1 shared publicationJessica L. Ward
Idaho National Laboratory, 1765 N. Yellowstone Hwy, Idaho Falls, ID, 83415. USA
1 shared publicationJoe Cardenas
Raytheon Missile Systems 1 , Albuquerque, New Mexico 87123, USA
1 shared publication
Latest Publications
- 1 December 2021
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 178, 109934
High purity 47Sc production using high-energy photons and natural vanadium targets
- 1 December 2021
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 178, 109934
High purity 47Sc production using high-energy photons and natural vanadium targets
- Open Access
- 1 July 2020
- Published by AIP Publishing in AIP Advances
- Vol. 10 (7) , 075008
Microwave radiation from interactions of modulated electron beams with solid matter
RF-modulated electron beams, such as those produced by an RF linear accelerator, propagating through vacuum, air, and solid matter are well known to drive signals in microwave cavities and waveguides via interactions with these structures. Past experiments with a microwave waveguide in a radiation-shielded vault indicated the presence of a multipath propagation phenomenon, hypothesized to be a result of reflections of RF-modulated x rays. In this work, we study the signals induced in a microwave coaxial cable from nearby beam interactions with materials commonly found in accelerator facilities in order to better understand RF production and propagation in these environments. Our results show that (1) when an RF-modulated electron beam is incident on a block of aluminum, lead, or concrete, the frequency content of the induced microwave signals is strongly dependent on the orientation of the block and the relative position of the detector, (2) at least some of the detected signals are consistent with reflections off of the blocks, and (3) beam interactions with the blocks can induce appreciable microwave signals in detectors located tens of cm from the block.
- 1 July 2020
- Published by AIP Publishing in AIP Advances
- Vol. 10 (7) , 075008
Open AccessMicrowave radiation from interactions of modulated electron beams with solid matter
RF-modulated electron beams, such as those produced by an RF linear accelerator, propagating through vacuum, air, and solid matter are well known to drive signals in microwave cavities and waveguides via interactions with these structures. Past experiments with a microwave waveguide in a radiation-shielded vault indicated the presence of a multipath propagation phenomenon, hypothesized to be a result of reflections of RF-modulated x rays. In this work, we study the signals induced in a microwave coaxial cable from nearby beam interactions with materials commonly found in accelerator facilities in order to better understand RF production and propagation in these environments. Our results show that (1) when an RF-modulated electron beam is incident on a block of aluminum, lead, or concrete, the frequency content of the induced microwave signals is strongly dependent on the orientation of the block and the relative position of the detector, (2) at least some of the detected signals are consistent with reflections off of the blocks, and (3) beam interactions with the blocks can induce appreciable microwave signals in detectors located tens of cm from the block.
- Open Access
- 1 December 2018
- Published by AIP Publishing in AIP Advances
- Vol. 8 (12) , 125117
Multi-plate interceptive electron beam energy diagnostic—Implementation and validation
A previous publication [P. D. McChesney, “Multi-plate interceptive electron beam energy diagnostic—Theoretical design,” AIP Adv. (submitted)] reported a new interceptive electron beam kinetic energy measurement technique based on the beam penetration depth within a stack of conductive plates and gave results on the theoretical design of such a device. This paper expands on this and gives further results on the actual implementation of the diagnostic. The device geometry and measurement electronics system are described in detail. A prototype version of the multi-plate diagnostic was fabricated and tested using an electron linear accelerator at the Idaho Accelerator Center (IAC). A high-precision magnetic spectrometer system was designed and built for the purpose of validating the multi-plate diagnostic’s energy measurement capabilities. It was found that the diagnostic provides electron beam energy estimates that are accurate to better than the 10% level.
- 1 December 2018
- Published by AIP Publishing in AIP Advances
- Vol. 8 (12) , 125117
Open AccessMulti-plate interceptive electron beam energy diagnostic—Implementation and validation
A previous publication [P. D. McChesney, “Multi-plate interceptive electron beam energy diagnostic—Theoretical design,” AIP Adv. (submitted)] reported a new interceptive electron beam kinetic energy measurement technique based on the beam penetration depth within a stack of conductive plates and gave results on the theoretical design of such a device. This paper expands on this and gives further results on the actual implementation of the diagnostic. The device geometry and measurement electronics system are described in detail. A prototype version of the multi-plate diagnostic was fabricated and tested using an electron linear accelerator at the Idaho Accelerator Center (IAC). A high-precision magnetic spectrometer system was designed and built for the purpose of validating the multi-plate diagnostic’s energy measurement capabilities. It was found that the diagnostic provides electron beam energy estimates that are accurate to better than the 10% level.