A simple technology for CuO/TiO 2 3D interface fabrication using nanocrystalline oxide powders
Authors:
- 13 February 2017
- journal article
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 32 (3) , 035019
Abstract
A CuO/TiO 2 interface with potential use for solar light conversion is studied. Thin films are synthesized using a mixture of commercially available nanocrystalline TiO 2 and CuO powders. Samples with mass concentrations from 5 to 10% of CuO in TiO 2 were prepared from a colloidal suspension using a ‘doctor blade’ technique. Heat treatment (500 °C, 1 h) was used to generate crystals necking and improve adhesion to substrates. X-ray diffraction analysis and scanning electron microscopy indicate that the CuO nanocrystals are smaller than those of TiO 2 . Since TiO 2 does not absorb light in the spectral range where the CuO absorption edge is located, it was possible to obtain an effective CuO absorption coefficient spectra and then extract the bandgap energy. The results confirm the potential use of CuO as a TiO 2 inorganic sensitizer for solar light. SEM images show a mesoporous structure for all samples that would facilitate penetration of a hole conductor and guarantee a large three-dimensional interface. Photocurrent direction with no bias confirms electron transfer from the CuO to the TiO 2 when CuO/TiO 2 films are used as photoelectrodes. Therefore, excited electrons in the CuO conduction band occupy levels with energy greater than the empty states in the TiO 2 conduction band. Possible technological improvements to increase electron collection are discussed.Keywords
This publication has 38 references indexed in Scilit:
- CuO/ZnO planar bilayer heterojunction grown by reactive dc magnetron sputteringJournal of Materials Science: Materials in Electronics, 2015
- Microstructural and optical studies of CuO thin films prepared by chemical ageing of copper substrate in alkaline ammonia solutionJournal of Alloys and Compounds, 2014
- Low temperature preparation of CuO nanospheres and urchin-shaped structures via hydrothermal routeJournal of Alloys and Compounds, 2014
- Comparison of solar cells sensitised by CdTe/CdSe and CdSe/CdTe core/shell colloidal quantum dots with and without a CdS outer layerThin Solid Films, 2014
- Quantum dot based molecular solar cellsCoordination Chemistry Reviews, 2014
- Synthesis of Cu/Cu2O Nanoparticles by Laser Ablation in Deionized Water and Their Annealing Transformation Into CuO NanoparticlesJournal of Nanoscience and Nanotechnology, 2013
- Copper oxide nanoparticle made by flame spray pyrolysis for photoelectrochemical water splitting – Part II. Photoelectrochemical studyInternational Journal of Hydrogen Energy, 2011
- Concepts of inorganic solid-state nanostructured solar cellsSolar Energy Materials and Solar Cells, 2011
- Materials Availability Expands the Opportunity for Large-Scale Photovoltaics DeploymentEnvironmental Science & Technology, 2009
- Cuprite, paramelaconite and tenorite films deposited by reactive magnetron sputteringApplied Surface Science, 2003