Elena Vigil
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Elena Vigil has a total of 89 co-authors. Here are the top co-authors by number of shared publications:
- Jose Antonio Ayllon
Departament de Química, Universitat Autònoma de Barcelona (UAB), Campus UAB s/n, 08193 Bellaterra, Spain
15 shared publications - Inti Zumeta-Dubé
University of Havana
10 shared publications Bernardo González
Materials Science and Technology Institute, Havana University, Havana, Cuba
7 shared publications- Concepción Domingo
Institut de Ciència de Materials de Barcelona (ICMAB), Consejo Superior de Investigaciones Científicas (CSIC), Campus UAB s/n, 08193 Bellaterra, Spain
6 shared publications Fresnel Forcade
Materials Science and Technology Institute, Havana University, Havana, Cuba
6 shared publicationsXavier Domènech
Autonomous University of Barcelona
6 shared publications
Latest Publications
- 24 March 2022
- Published by Springer Nature in Applied Physics A
- Vol. 128 (4) , 1-10
Analysis of the photocurrent from CuO/TiO2 nanostructured photoelectrodes to elucidate the benefits of nanocrystal size decrease
- 24 March 2022
- Published by Springer Nature in Applied Physics A
- Vol. 128 (4) , 1-10
Analysis of the photocurrent from CuO/TiO2 nanostructured photoelectrodes to elucidate the benefits of nanocrystal size decrease
- 1 July 2020
- Published by Elsevier in Materials Letters
- Vol. 270
Nanostructured CuO film grown from solution by preferential microwave heating of the conducting glass substrate
- 1 July 2020
- Published by Elsevier in Materials Letters
- Vol. 270
Nanostructured CuO film grown from solution by preferential microwave heating of the conducting glass substrate
- 1 September 2018
- Published by Elsevier in Ceramics International
- Vol. 44 (13) , 16058-16061
Size control of CuO nanocrystals grown within TiO2 mesopores with a simple technique
- 1 September 2018
- Published by Elsevier in Ceramics International
- Vol. 44 (13) , 16058-16061
Size control of CuO nanocrystals grown within TiO2 mesopores with a simple technique
- 1 August 2018
- Published by Elsevier in Thin Solid Films
- Vol. 660, 386-390
Nanostructured CuO films deposited on fluorine doped tin oxide conducting glass with a facile technology
- 1 August 2018
- Published by Elsevier in Thin Solid Films
- Vol. 660, 386-390
Nanostructured CuO films deposited on fluorine doped tin oxide conducting glass with a facile technology
- 13 February 2017
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 32 (3) , 035019
A simple technology for CuO/TiO 2 3D interface fabrication using nanocrystalline oxide powders
A CuO/TiO 2 interface with potential use for solar light conversion is studied. Thin films are synthesized using a mixture of commercially available nanocrystalline TiO 2 and CuO powders. Samples with mass concentrations from 5 to 10% of CuO in TiO 2 were prepared from a colloidal suspension using a ‘doctor blade’ technique. Heat treatment (500 °C, 1 h) was used to generate crystals necking and improve adhesion to substrates. X-ray diffraction analysis and scanning electron microscopy indicate that the CuO nanocrystals are smaller than those of TiO 2 . Since TiO 2 does not absorb light in the spectral range where the CuO absorption edge is located, it was possible to obtain an effective CuO absorption coefficient spectra and then extract the bandgap energy. The results confirm the potential use of CuO as a TiO 2 inorganic sensitizer for solar light. SEM images show a mesoporous structure for all samples that would facilitate penetration of a hole conductor and guarantee a large three-dimensional interface. Photocurrent direction with no bias confirms electron transfer from the CuO to the TiO 2 when CuO/TiO 2 films are used as photoelectrodes. Therefore, excited electrons in the CuO conduction band occupy levels with energy greater than the empty states in the TiO 2 conduction band. Possible technological improvements to increase electron collection are discussed.
- 13 February 2017
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 32 (3) , 035019
A simple technology for CuO/TiO 2 3D interface fabrication using nanocrystalline oxide powders
A CuO/TiO 2 interface with potential use for solar light conversion is studied. Thin films are synthesized using a mixture of commercially available nanocrystalline TiO 2 and CuO powders. Samples with mass concentrations from 5 to 10% of CuO in TiO 2 were prepared from a colloidal suspension using a ‘doctor blade’ technique. Heat treatment (500 °C, 1 h) was used to generate crystals necking and improve adhesion to substrates. X-ray diffraction analysis and scanning electron microscopy indicate that the CuO nanocrystals are smaller than those of TiO 2 . Since TiO 2 does not absorb light in the spectral range where the CuO absorption edge is located, it was possible to obtain an effective CuO absorption coefficient spectra and then extract the bandgap energy. The results confirm the potential use of CuO as a TiO 2 inorganic sensitizer for solar light. SEM images show a mesoporous structure for all samples that would facilitate penetration of a hole conductor and guarantee a large three-dimensional interface. Photocurrent direction with no bias confirms electron transfer from the CuO to the TiO 2 when CuO/TiO 2 films are used as photoelectrodes. Therefore, excited electrons in the CuO conduction band occupy levels with energy greater than the empty states in the TiO 2 conduction band. Possible technological improvements to increase electron collection are discussed.
- Open Access
- 6 November 2015
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 72 (2) , 20404
On fundamental mechanisms in dye sensitized solar cells through the behaviour of different mesoporous titanium dioxide films
Understanding mechanisms in DSSCs is fundamental for their improvement; this includes the nanocrystalline semiconducting layer behaviour. Different mesoporous TiO2 layers are fabricated and analyzed for possible use in DSSC solar cells. The preparations included the addition of P123 triblock copolymer as structuring agent to the synthesized anatase sol. This preparation was also mixed with Degussa P25 TiO2 nanoparticles in one case and polystyrene latex in another. Mesoporous mixed TiO2-SiO2 thin layers were also analyzed. The diverse morphologies and features are studied by microscopic techniques and by means of spectral quantum efficiency of a photoelectrochemical cell (PEC) that uses as photoelectrode the unsensitized porous TiO2 layer. Contact angle measurements are also performed. We have found that a very high specific area due to very small nanocrystals and small pores can hinder electrolyte penetration in the pores formed by TiO2 nanograins, affecting photoelectrodes efficiency.
- 6 November 2015
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 72 (2) , 20404
Open AccessOn fundamental mechanisms in dye sensitized solar cells through the behaviour of different mesoporous titanium dioxide films
Understanding mechanisms in DSSCs is fundamental for their improvement; this includes the nanocrystalline semiconducting layer behaviour. Different mesoporous TiO2 layers are fabricated and analyzed for possible use in DSSC solar cells. The preparations included the addition of P123 triblock copolymer as structuring agent to the synthesized anatase sol. This preparation was also mixed with Degussa P25 TiO2 nanoparticles in one case and polystyrene latex in another. Mesoporous mixed TiO2-SiO2 thin layers were also analyzed. The diverse morphologies and features are studied by microscopic techniques and by means of spectral quantum efficiency of a photoelectrochemical cell (PEC) that uses as photoelectrode the unsensitized porous TiO2 layer. Contact angle measurements are also performed. We have found that a very high specific area due to very small nanocrystals and small pores can hinder electrolyte penetration in the pores formed by TiO2 nanograins, affecting photoelectrodes efficiency.
- 1 October 2015
- Published by Elsevier in Materials Research Bulletin
- Vol. 70, 248-253
Impact of the chemical precursor on the crystalline constitution of nano-CuO/TiO2 films
- 1 October 2015
- Published by Elsevier in Materials Research Bulletin
- Vol. 70, 248-253
Impact of the chemical precursor on the crystalline constitution of nano-CuO/TiO2 films
- 22 March 2014
- Published by Springer Nature
- p. 289-293
Experimental Semiconductor Physics: The Will to Contribute to the Country’s Economic Development
- 22 March 2014
- Published by Springer Nature
- p. 289-293
Experimental Semiconductor Physics: The Will to Contribute to the Country’s Economic Development
- 1 November 2011
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 171 (2) , 87-92
An ultraviolet selective photodetector based on a nanocrystalline TiO2 photoelectrochemical cell
- 1 November 2011
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 171 (2) , 87-92
An ultraviolet selective photodetector based on a nanocrystalline TiO2 photoelectrochemical cell