Aerodynamic noise optimization of a voluteless centrifugal fan with biomimetic blades inspired by eagle-owl wingtip morphology
Authors:
- Jianhua FanJFJianhua Fan
- Xiangqin WangXWXiangqin Wang
- Daizhe YangDYDaizhe Yang
- Lu WangLWLu Wang
- Zhiwu HanZHZhiwu Han
- Yuanhu CuiYCYuanhu Cui
- Bo LiBLBo Li
- Jinshi ChenJCJinshi Chen
- 1 July 2025
- journal article
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (7)
Abstract
Inspired by the low-noise characteristics of the eagle-owl nocturnal flight, two novel designs for blades of the voluteless centrifugal fan are proposed to improve the aerodynamic performance and reduce the noise. A serrated structure inspired by the eagle-owl wingtips at the trailing edge is adopted to design and optimize the blade. Based on the computational fluid dynamics methods and the Ffowcs Williams–Hawkings equation, the impact of the serrated leading and trailing edges on the aerodynamic performance and acoustic characteristics of a fan is investigated. The optimal geometric parameters of the bionic sawtooth are determined. Subsequently, a comprehensive comparison of the flow characteristics and noise spectra among the fan with the original blade (OBLE), the serrated leading-edge blade (SLBE), and the serrated trailing-edge blade (STBE) is conducted, revealing the control mechanism of the SLBE and STBE on the flow properties and noise optimization principles. Results demonstrate that the SLBE fan not only mitigates pressure fluctuations and optimizes vortices but also increases the maximum flow rate by 1.76%. Although the STBE fan also optimizes pressure and vortices, its efficiency slightly decreases due to reduced blade lift. However, the STBE fan achieves outstanding noise suppression, reducing the sound pressure level (SPL) by 6.42 dB compared to the OBLE fan. While the SLBE fan yields a limited SPL reduction of only 1.97 dB. Additionally, the noise energy shift at 1364 Hz demonstrates frequency modulation caused by the serrations. The blade trailing edge is identified as the primary noise source, and the STBE fan significantly attenuates broadband and tonal noise by optimizing the airflow disturbance suppression at the impeller outlet. These findings validate the feasibility of using biomimetic serrated designs to optimize the performance of voluteless centrifugal fans.Keywords
Funding Information
- Department of Science and Technology of Jilin Province (20240303040NC)
- China Postdoctoral Science Foundation (2024T170342)
This publication has 46 references indexed in Scilit:
- Large eddy simulation for aeroacoustic prediction and characterization of electronics cooling axial fans under various operating conditionsApplied Acoustics, 2025
- Experimental investigation on aerodynamic noise of a small-scale multi-blade centrifugal fanApplied Acoustics, 2024
- Noise Optimization and Experimental Verification of Voluteless Centrifugal FanAcoustics Australia, 2023
- Aerodynamic performance improvement and noise control for the multi-blade centrifugal fan by using bio-inspired bladesEnergy, 2022
- Noise control of a backward-curved centrifugal fan by reducing pressure fluctuations between the impeller and cut-off surfaceApplied Acoustics, 2021
- Biomimetic flow control techniques for aerospace applications: a comprehensive reviewReviews in Environmental Science and Bio/Technology, 2021
- Research on aerodynamic performance of a novel dolphin head-shaped bionic airfoilEnergy, 2021
- Aerodynamic noise prediction of a centrifugal fan considering the volute effect using IBEMApplied Acoustics, 2018
- Experimental investigation of metal foam for controlling centrifugal fan noiseApplied Acoustics, 2016
- Aerodynamic performance effects of leading-edge geometry in gas-turbine bladesApplied Energy, 2010