Flexor Tendon Repair Using a New Looped Six- and Eight-Strand Technique—A Biomechanical Analysis
Open Access
- 3 March 2026
- journal article
- research article
- Published by MDPI AG in Journal of Personalized Medicine
- Vol. 16 (3) , 144
Abstract
Background/Objectives: Tendon injuries are a common cause of emergency department presentation and impose a substantial socioeconomic burden. Despite advances in surgical techniques, rupture rates after primary repair remain at 3.1–11.7%. Contemporary repairs typically combine at least four core strands with epitenon sutures to achieve sufficient tensile strength while limiting bulk. Increasing the number of core strands improves strength but may impair gliding and healing. Looped core sutures increase the effective strand number without additional knots or passes, potentially allowing omission of the epitenon suture and thus limiting repair complexity and bulk. The objective was to determine whether six- or eight-strand looped core suture techniques provide sufficient tensile strength to allow omission of an epitenon suture without excessive repair bulk, compared with a conventional four-strand Adelaide repair. Methods: One hundred and twenty human flexor digitorum profundus tendons were harvested from fresh-frozen anatomical specimens and allocated to six groups: Adelaide (four-strand) ± epitenon suture, six-strand ± epitenon suture, and eight-strand ± epitenon suture. Repairs were performed in zone II. The cross-sectional area (CSA) was measured before and after repair to quantify bulkiness. Tendons were tested to failure using axial tensile loading, and the failure mode was recorded. Results: The Adelaide with epitenon suture, six-strand with epitenon suture, and eight-strand with epitenon suture demonstrated significantly higher load to failure than the Adelaide without epitenon suture. The eight-strand without epitenon suture achieved a load to failure comparable to the Adelaide with epitenon suture, while also resulting in a smaller increase in CSA. The Adelaide with epitenon suture showed the greatest increase in CSA, while the six-strand without epitenon suture showed the smallest increase in CSA. Suture breakage was the predominant failure mode. Conclusions: An eight-strand looped core suture without epitenon suture provides comparable tensile strength to the conventional Adelaide repair with epitenon suture while minimizing repair bulk. The six-strand with epitenon suture demonstrated similar tensile strength to higher-strand techniques and may represent a mechanically adequate alternative with less tissue manipulation. These findings support a more individualized approach to flexor tendon repair, in which the choice of repair construct can be tailored to biomechanical demands and clinical context rather than applying a single uniform technique.Keywords
This publication has 29 references indexed in Scilit:
- The effect of the number of strands and knot throws of core suture techniques on the mechanical properties of the repaired flexor tendonJournal of Orthopaedic Research, 2024
- Hand Flexor Tendon RepairHand Clinics, 2023
- Flexor Tendon Repair TechniquesHand Clinics, 2023
- Trends of hand injuries presenting to US emergency departments: A 10-year national analysisThe American Journal of Emergency Medicine, 2021
- Biomechanical analysis of a new 8-strand technique for flexor tendon repairHand Surgery and Rehabilitation, 2020
- A review of cyclic testing protocols for flexor tendon repairsClinical Biomechanics, 2019
- The impact of different peripheral suture techniques on the biomechanical stability in flexor tendon repairArchives of orthopaedic and trauma surgery, 2017
- Rehabilitation following surgery for flexor tendon injuries of the handCochrane Database of Systematic Reviews, 2017
- Effects of Tension Across the Tendon Repair Site on Tendon Gap and Ultimate StrengthThe Journal of Hand Surgery, 2012
- Comparison of zone II flexor tendon repairs using an in vitro linear cyclic testing protocolClinical Biomechanics, 2005