Numerical simulation of co-firing oil palm fronds and lignite coal injected at different burning rates in tangential pulverized coal burner
Open Access
- 21 April 2025
- journal article
- Published by Center of Biomass and Renewable Energy Scientia Academy in International Journal of Renewable Energy Development
- Vol. 14 (3) , 588-602
Abstract
Reducing CO₂ emissions and utilizing biomass, particularly palm oil mill waste, is crucial for addressing climate change, enhancing air quality, and advancing environmentally sustainable clean technology innovations. Palm fronds can serve as a renewable fuel source with minimal emissions, providing a viable co-firing option for coal in coal-fired power plants (PLTU). Although previous studies have shown promising CO₂ emission reductions through co-combustion of oil palm fronds and coal, there is still no comprehensive analysis of the combustion characteristics and emission behavior when varying the burner injection zone, thus further research is required. This study performs a numerical analysis using three-dimensional computational-fluid dynamics (CFD) to examine the co-burning process of palm fronds alongside low-calorie coal (LRC) at the Pacitan PLTU, which has a capacity of 315 megawatts. The co-burning simulation, incorporating a 5% substitution of palm fronds in each burner, was conducted to differentiate between burners A and D, aiming to determine the optimum injection area. The findings of the simulation reveal inconsistencies in combustion properties, particularly regarding temperature allocation. The primary results demonstrate a temperature rise when palm fronds are used as a co-firing fuel, attributed to their greater volatility and oxygen content compared to coal. The most notable decrease in CO₂ emissions was observed with the substitution of 5% oil palm fronds in burner B; however, the reduction was not substantial, as indicated by a mass fraction value of 0.128 at the boiler discharge. An increase in NOx mass fraction was also observed due to the organic nitrogen in palm frond biomass, which decomposes rapidly during combustion at high temperatures. This co-firing technology is expected to provide a means for lowering emissions and improving the use of alternative fuels as a substitution for fossil fuels in a time to come.Keywords
This publication has 46 references indexed in Scilit:
- Prospect and challenges of producing carbon black from oil palm biomass: A reviewBioresource Technology Reports, 2023
- CFD investigation on combustion and NO emission characteristics in a 600 MW wall-fired boiler under high temperature and strong reducing atmosphereApplied Thermal Engineering, 2017
- Retrofitting existing coal power plants through cofiring with hydrothermally treated empty fruit bunch and a novel integrated systemApplied Energy, 2017
- Two-phase anaerobic digestion of municipal solid wastes enhanced by hydrothermal pretreatment: Viability, performance and microbial community evaluationApplied Energy, 2017
- Review and experimental study on pyrolysis and hydrothermal liquefaction of microalgae for biofuel productionApplied Energy, 2017
- Modeling of Solid and Bio-Fuel Combustion Technologies2016
- Steam explosion of oil palm residues for the production of durable pelletsApplied Energy, 2015
- Integration of energy-efficient empty fruit bunch drying with gasification/combined cycle systemsApplied Energy, 2015
- The effect of the hydrothermal carbonization process on palm oil empty fruit bunchBiomass and Bioenergy, 2012
- The mechanisms of hydrothermal deconstruction of lignocellulose: New insights from thermal–analytical and complementary studiesBioresource Technology, 2011