Process- and material-induced heterogeneities in recycled thermoplastic composites
Open Access
- 15 December 2020
- journal article
- research article
- Published by SAGE Publications in Journal of Thermoplastic Composite Materials
- Vol. 35 (12) , 2530-2551
Abstract
A novel recycling solution for thermoplastic composites (TPCs) was recently implemented. The processing steps comprise shredding of TPC offcuts to flakes of a few centimetres, melting and blending of the flakes in a low-shear mixer, extrusion of a molten mixed dough and subsequent compression moulding in a press. This material and process are similar to the compression moulding of long-fibre thermoplastics (LFTs) that have been in the market for decades, such as glass mat thermoplastics (GMT) or direct-LFT. However, the input material in this recycling route consists of multi-layered woven flakes, which is very different from the pellets or chopped rovings of other LFTs. Process- and material-induced heterogeneities such as fibre orientation, percolation, variation of fibre fraction, or fibre attrition may be different for this new material. The development of this recycling technology and future industrial applications require more confidence in the material and process. The objective of this study is to characterise these heterogeneities for this recycling solution, and compare them to those generated in regular LFTs. It was found that the process- and material-induced heterogeneities of the recycled TPCs are similar to other LFTs, for the aspects listed here: fibre orientation, percolation, variation of fibre fraction and fibre attrition. In comparison to GMT, the effect of the mixing step is particularly noticeable on the local variation of fibre fraction within the panels. Industrial applications of this recycling route will benefit from this similarity, as it improves the confidence in the material and process combination.Keywords
Funding Information
- Dutch Organisation of Applied Research - SIA (SIA-RAAK 2014-01-72PRO)
This publication has 17 references indexed in Scilit:
- Design, Manufacturing and Testing of a Rotorcraft Access Panel Door From Recycled Carbon Fiber Reinforced Polyphenylenesulfide2019
- Development of a closed-loop recycling process for discontinuous carbon fibre polypropylene compositesComposites Part B: Engineering, 2018
- Impregnation quality of shredded semipreg after compression mouldingAIP Conference Proceedings, 2017
- Thermoplastic carbon fibre-reinforced polymer recycling with electrodynamical fragmentationJournal of Thermoplastic Composite Materials, 2016
- Direct Processing of Long Fiber Reinforced Thermoplastic Composites and their Mechanical Behavior under Static and Dynamic Load (Print-on-Demand)2015
- Rheology of Highly Concentrated Fiber Suspensions2015
- Mechanical properties of polypropylene compositesJournal of Thermoplastic Composite Materials, 2011
- Mechanism of fiber–matrix separation in ribbed compression molded partsPolymer Composites, 2007
- Design and Development of a Long Fiber Thermoplastic Bus SeatJournal of Thermoplastic Composite Materials, 2006
- The influence of fibre length and concentration on the properties of glass fibre reinforced polypropylene: 5. Injection moulded long and short fibre PPComposites Part A: Applied Science and Manufacturing, 2002