Activation Energy of Conduction for Use in Temperature Corrections on Electrical Measurements of Concrete
- 1 January 2019
- journal article
- research article
- Published by ASTM International in Advances in Civil Engineering Materials
- Vol. 8 (1) , 158-170
Abstract
The formation factor obtained through electrical resistivity measurements is becoming a popular method to determine transport properties of concrete. Resistivity measurements are dependent on multiple factors, including degree of saturation, pore solution conductivity, and temperature. The Arrhenius equation is used to correct electrical resistivity for temperature effects using an activation energy of conduction (Ea-cond). This parameter has been measured on a wide variety of materials, including pore solutions, pastes, mortars, and concretes (with a variety of saturation states). The reported values of Ea-cond typically range from 9 to 39 kJ/mol. This article examines the factors affecting Ea-cond in order to select an appropriate temperature correction. In this study, Ea-cond was determined from data measured on various concrete mixtures used in transportation infrastructure applications as well as extracted and simulated pore solutions. The Ea-cond of pore solutions remains relatively constant (an average value of 13.9 ± 1.5 kJ/mol) for typical pore solutions and was slightly lower than the Ea-cond of saturated specimens (an average value of 15.8 kJ/mol). It was found that Ea-cond increases as the degree of saturation of the specimen is reduced. Drying increases the ionic concentration of the fluid in the pores; however, this does not explain the changes in Ea-cond. The effects of drying were determined to be primarily due to a change in the volume of the conductive fluid film in the concrete and in the connectivity of the fluid-filled pores. While it is better to directly measure the Ea-cond of a concrete mixture, this is not always feasible or practical. In such cases, for pore solutions, a value of 13.9 kJ/mol can be used, and for saturated concretes, a value of 15.8 kJ/mol can be used. For concretes with a varying degree of saturation, the Ea-cond can be estimated using the developed equation.Keywords
This publication has 27 references indexed in Scilit:
- Factors that Influence Electrical Resistivity Measurements in Cementitious SystemsTransportation Research Record: Journal of the Transportation Research Board, 2013
- Surface Resistivity Measurements Evaluated as Alternative to Rapid Chloride Permeability Test for Quality Assurance and AcceptanceTransportation Research Record: Journal of the Transportation Research Board, 2012
- Formula for the Viscosity of a Glycerol−Water MixtureIndustrial & Engineering Chemistry Research, 2008
- Electrical conductivity of drying cement pasteMaterials and Structures, 2006
- Study of the Joule effect on rapid chloride permeability values and evaluation of related electrical properties of concretesCement and Concrete Research, 2004
- Electrical conductivity, diffusion, and permeability of Portland cement-based mortarsCement and Concrete Research, 2000
- Effects of Temperature on Conduction and Polarization in Portland Cement MortarJournal of the American Ceramic Society, 1995
- Viscosity-temperature correlation for glycerol-water solutionsIndustrial & Engineering Chemistry Research, 1987
- Densities, viscosities, and diffusivities in aqueous sodium hydroxide-potassium ferri- and ferro-cyanide solutionsJournal of Chemical & Engineering Data, 1985
- Expression and analysis of pore fluids from hardened cement pastes and mortarsCement and Concrete Research, 1981