Mechanical properties and morphologies of polypropylene with different sizes of calcium carbonate particles
Authors:
- 23 June 2006
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 27 (4) , 443-450
Abstract
Three polypropylene (PP) matrixes with different intrinsic toughness were used to study the morphologies and mechanical properties of PP filled with four sizes of calcium carbonate particles. PP1 was a homopolymer, PP2 was a propylene‐ethylene copolymer, and PP3 was a mixture of PP1 and PP2 (PP1:PP2 = 1:1, weight ratio). Calcium carbonate (CC25, CC4, CC1.8, and CC0.07) with an average particle size of 25, 4, 1.8, and 0.07 μm, respectively, was used. It was clear that the PP matrix and filler size had key effects on improvement of mechanical properties of PP matrix. For all three PP matrixes, the yield strength, the flexural strength and modulus of the composites filled with CC25, CC4, and CC1.8 could be regarded as the same. But the yield strength, the flexural strength and modulus of composites filled with CC0.07 were obviously lower than those of composites filled with other sizes of particles. Among four sizes of calcium carbonate particles, CC0.07 had the best toughening effect to improve the impact strength of PP matrix, and the toughening effect of CC0.07 was influenced by PP matrix. For all PP matrixes, only in the case of moderate matrix toughness (PP3 matrix), the composite could receive the highest extent of toughness increase (4.3 times that of matrix). With regard to all PP composites, the best combination of properties was PP2 nanocomposite filled with 20 wt% CC0.07. POLYM. COMPOS., 27:443–450, 2006. © 2006 Society of Plastics EngineersKeywords
This publication has 28 references indexed in Scilit:
- Crosslinkable polypropylene composites made by the introduction of silane moietiesJournal of Applied Polymer Science, 2005
- Influence of filler particles on deformation and fracture mechanism of isotactic polypropyleneJournal of Materials Processing Technology, 2004
- Effects of calcium carbonate and its purity on crystallization and melting behavior, mechanical properties, and processability of syndiotactic polypropyleneJournal of Applied Polymer Science, 2004
- Comparison of the mechanical properties and interfacial interactions between talc, kaolin, and calcium carbonate filled polypropylene compositesJournal of Applied Polymer Science, 2004
- Toughening of polypropylene with calcium carbonate particlesPolymer, 2003
- Comonomer effect on the mechanical and morphological behavior on the calcite‐filled PP, CoPP, and TerPPJournal of Applied Polymer Science, 2002
- Toughening of isotactic polypropylene with CaCO 3 particlesPolymer, 2002
- Assessment of efficacy of trivalent lanthanum complex as surface modifier of calcium carbonateJournal of Applied Polymer Science, 2001
- Polymer toughness and impact resistancePolymer Engineering & Science, 1999
- Polypropylene–rubber blends: 5. Deformation mechanism during fracturePolymer, 1999