Polarization charges induced in wurtzite III-Nitride crystals make this material system unique by realizing a high concentration of two-dimensional electron gas (2DEG) in heterojunctions without impurity doping. In GaN, the polarization charges induced on c-plane surface are as dense as the charges by ionized impurities with a quite high sheet concentration of 2.12 x 10 13 cm -2 . Such a large amount of charge should affect the electrostatic potential in the system under consideration. Although in general the polarization charges are considered to be located exactly at the surface (or interface) of a crystal (or heterostructure), we propose a model that the polarization charges distribute in a thin layer, as thin as a height of a unit cell, at the surface (or interface) [1]. This model enables to explain the experimental results revealing that the Schottky barrier height of Ga-polar GaN is about 0.2 V higher than that of N-polar GaN. A significant band bending in the thin layer where the polarization charges distribute pushes the conduction band energy upward (downward) beneath the surface of the Ga-polar (N-polar) GaN depending on the sign of the polarization charges. As a result, the barrier height increases (decreases) in the Ga-polar (N-polar) GaN, and the calculation result suggests that the thickness of the layer where the polarization charges distribute is about 5 Å to adjust to the 0.2 V difference in the barrier heights between the two polarities. The thickness of 5 Å invokes the height of the unit cell along c-axis of GaN and makes sense if we consider that the dipoles in unit cells are the origin of the polarization charges. Next, this polarization model is applied to heterojunctions. For a Ga-polar AlGaN/GaN heterostructure, for example, the conventional model assumes that the charges with a sum of the positive polarization charges at the bottom of the AlGaN layer and the negative polarization charges at the top of the GaN layer exist exactly at the heterojunction [2]. The proposed model assumes that the positive polarization charges of AlGaN distribute in a thin layer above the heterojunction, and the negative polarization charges of GaN distribute in a thin layer below the heterojunction. The calculated band profile exhibits a shrink of the band offset at the AlGaN/GaN heterojunction caused by a significant band bending in both thin layers with a large concentration of polarization charges. The shrunken band offset helps obtain a calculated carrier concentration agreeing with experimental results while the conventional model tends to overestimate the carrier concentration. In summary, the impact of the polarization charges on the Schottky barrier height and the band offset at a heterojunction of III-N material systems are revealed by the proposed model assuming the surface (or interface) polarization charges distribute in a thin layer with a unit cell height. The proposed model helps design heterostructures for high electron mobility transistors with a target threshold voltage and carrier concentration. This work is partly supported by JSPS KAKENHI #23K17322 and #24H00425. [1] T. Suemitsu and I. Makabe, Phys. Status Solidi B257 , 1900528 (2020). [2] T. Suemitsu, Compound Semiconductor Week 2024, Lund, Sweden, P16 (2024).