A Shared Charging Channel for Power and Auxiliary Batteries in Electric Vehicles
- 14 September 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 71 (7) , 8199-8203
Abstract
In electric vehicles (EVs), the wireless charging system (WCS) for the high-voltage (HV) power battery and the auxiliary power module (APM) for the low-voltage (LV) auxiliary battery possess some similar power conversion stages. This letter proposes an integrated solution for WCS and APM with the shared magnetic coupler, compensation network, and power electronics converter. The coupling coil for APM is incorporated with reverse windings so as to couple with the receiving coil but decouple with the transmitting coil of the WCS system. Thus, it forms magnetic couplers for APM. The proposed system can work in the mode where WCS and APM are in operation with power from the power grid, or in the mode where APM is in operation with power from the HV battery to the LV battery. The integration of WCS and APM can reduce its weight and cost and improve the power density of the EV charging system. The experimental results have proved the effectiveness of the proposal.Keywords
Funding Information
- National Natural Science Foundation of China (52107183)
- Natural Science Foundation of Fujian Province (2022J06011)
This publication has 14 references indexed in Scilit:
- Passive Paralleling of Multi-Phase Diode Rectifier for Wireless Power Transfer SystemsIEEE Transactions on Circuits and Systems II: Express Briefs, 2022
- Integration of Onboard Charger and Wireless Charging System For Electric Vehicles With Shared Coupler, Compensation, and RectifierIEEE Transactions on Industrial Electronics, 2022
- A New Magnetic Coupler With High Rotational Misalignment Tolerance for Unmanned Aerial Vehicles Wireless ChargingIEEE Transactions on Power Electronics, 2022
- Simultaneous Wireless Power and Data Transfer: A Comprehensive ReviewIEEE Transactions on Power Electronics, 2021
- A Current-fed Three-port DC/DC Converter for Integration of On-board Charger and Auxiliary Power Module in Electric Vehicles2021
- An Effective Integration of APM and OBC With Simultaneous Operation and Entire ZVS Range for Electric VehicleIEEE Transactions on Power Electronics, 2021
- Thermal Evaluation of an Inductive Power Transfer Pad for Charging Electric VehiclesIEEE Transactions on Industrial Electronics, 2021
- Onboard Battery Chargers for Plug-in Electric Vehicles With Dual Functional Circuit for Low-Voltage Battery Charging and Active Power DecouplingIEEE Access, 2018
- A Primary Full-Integrated Active Filter Auxiliary Power Module in Electrified Vehicles With Single-Phase Onboard ChargersIEEE Transactions on Power Electronics, 2017
- Multi-functional On-board Battery Charger for Plug-in Electric VehiclesIEEE Transactions on Industrial Electronics, 2014