Preparation of fine fiberglass‐resin powders from waste printed circuit boards by different milling methods for reinforcing polypropylene composites
- 4 June 2015
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 132 (35)
Abstract
In this study, different milling methods were used to prepare fine fiberglass‐resin powders (FRP) from waste printed circuit boards for the sake of obtaining high‐performance polypropylene (PP)/FRP composite. The processability and appearance of composites can be greatly improved through further milling of FRP; smaller average particle size and narrower particle size distribution can be obtained by pan milling as compared with jet milling and planetary ball milling. Mechanical test results showed that fine FRP prepared by pan milling could be used as reinforcing fillers in the PP composites and possessed better mechanical properties than other two milling methods. The mechanical properties was also confirmed by scanning electron microscopy studies which indicated that the dispersion of FRP and interfacial adhesion between fiberglass and PP matrix was much better by pan milling. Meanwhile, the heterogeneous nucleation effect of FRP by pan milling was more obvious. The above results indicate that solid‐state shear is a new method for producing fine FRP and high‐performance PP composites filled with FRP. © 2015 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015, 132, 42494.Keywords
This publication has 21 references indexed in Scilit:
- A review of using waste and virgin polymer in pavementConstruction and Building Materials, 2012
- Response to Waste Electrical and Electronic Equipments in China: Legislation, recycling system, and advanced integrated processEnvironmental Science & Technology, 2012
- Multifunctional high‐density polyethylene nanocomposites produced by incorporation of exfoliated graphene nanoplatelets 2: Crystallization, thermal and electrical propertiesPolymer Composites, 2012
- Performance and thermal behavior of wood plastic composite produced by nonmetals of pulverized waste printed circuit boardsJournal of Hazardous Materials, 2010
- Wood Plastic Composite Produced by Nonmetals from Pulverized Waste Printed Circuit BoardsEnvironmental Science & Technology, 2009
- Application of glass-nonmetals of waste printed circuit boards to produce phenolic moulding compoundJournal of Hazardous Materials, 2008
- Environmental contamination from electronic waste recycling at Guiyu, southeast ChinaJournal of Material Cycles and Waste Management, 2006
- Solid‐phase preparation of ultra‐fine PA6 powder through pan‐millingPolymer Engineering & Science, 2001
- A study on the pan‐milling process and the pulverizing efficiency of pan‐mill type equipmentPolymer Engineering & Science, 1997
- The use of recycled printed circuit boards as reinforcing fillers in the polyester compositeJournal of Environmental Science and Health . Part A: Environmental Science and Engineering and Toxicology, 1996