3D printable silicone compositions exhibiting high toughness and low durometer
- 13 May 2025
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 40 (10) , 1498-1510
Abstract
No abstract availableKeywords
Funding Information
- Lawrence Livermore National Laboratory
This publication has 35 references indexed in Scilit:
- Controlled In Situ Foaming for Mechanical Responsiveness of Architected FoamsAdvanced Engineering Materials, 2023
- Direct ink writing of reinforced polydimethylsiloxane elastomer composites for flexure sensorsJournal of Applied Polymer Science, 2022
- 3D-printed mesh membranes with controllable wetting state for directional droplet transportationColloids and Surfaces A: Physicochemical and Engineering Aspects, 2022
- Control of Mullins stress softening in silicone elastomer composites by rational design of fumed silica fillersComposites Science and Technology, 2021
- Biocompatible Soft Fluidic Strain and Force Sensors for Wearable DevicesAdvanced Functional Materials, 2018
- Custom 3D Printable Silicones with Tunable StiffnessMacromolecular Rapid Communications, 2017
- Topology Optimized Architectures with Programmable Poisson's Ratio over Large DeformationsAdvanced Materials, 2015
- Effect of the Mullins softening on mode I fracture of carbon-black filled rubbersInternational Journal of Fracture, 2015
- Three‐Dimensional Printing of Elastomeric, Cellular Architectures with Negative StiffnessAdvanced Functional Materials, 2014
- Optimisation of a pretreatment method to reach the basic elasticity of filled rubber materialsArchive of Applied Mechanics, 2013