The small-scale limits of electron beam melt additive manufactured Ti–6Al–4V octet-truss lattices
Open Access
- 1 September 2022
- journal article
- conference paper
- Published by AIP Publishing in AIP Advances
- Vol. 12 (9) , 095021
Abstract
The emergence of powder-based additive manufacturing (AM) processes, such as electron beam melting (EBM), enables the one step manufacture of microarchitected metamaterials from topology optimized models. However, many applications are optimized by low relative density lattices with slender trusses whose diameter approaches small multiples of largest powder particles, potentially resulting in surface roughness. The thermal history experienced by alloy powders also modifies the alloy microstructure, and thus mechanical behavior, posing a significant challenge to metallic metamaterial designs and fabrication. We therefore build and characterize the multiscale structure and mechanical properties of EBM manufactured Ti–6Al–4V octet truss lattices with strut diameters approaching the particle diameter-imposed fabrication limit. We measure the dependence of their relative density, elastic modulus, and compressive strength on the fabrication process-controlled truss topology and microstructure, and compare them to identical smooth surface structures made from an annealed, wrought version of the same alloy built using a snap-fit assembly method. Micro-x-ray tomography confirmed that the lattice strut surfaces were covered with partially melted powder particles, resulting in about 29% of the lattice mass that inefficiently supported the applied loads. The use of a powder bed held at a temperature of 600–700 °C also resulted in a lamellar α/β phase microstructure with an elastic modulus, yield strength, and a ductility that were less than the equiaxed α/β microstructure of snap-fit assembled structures. However, the higher tangent modulus of the lamellar AM processed alloy resulted in significant strengthening of EBM lattices that failed by inelastic buckling during compression. The ability to increase the alloy tangent modulus during an EBM build process therefore provides a promising approach for increasing lattice compressive strength and therefore compensates for surface roughness induced losses.Keywords
Funding Information
- National Aeronautics and Space Administration (80NSS18K0257)
This publication has 73 references indexed in Scilit:
- The compressive and shear response of titanium matrix composite lattice structuresActa Materialia, 2010
- Microstructures and mechanical properties of electron beam-rapid manufactured Ti–6Al–4V biomedical prototypes compared to wrought Ti–6Al–4VMaterials Characterization, 2009
- Shear behavior of aluminum lattice truss sandwich panel structuresMaterials Science and Engineering: A, 2008
- A multifunctional heat pipe sandwich panel structureInternational Journal of Heat and Mass Transfer, 2008
- Compressive behavior of age hardenable tetrahedral lattice truss structures made from aluminiumActa Materialia, 2004
- The effects of topology upon fluid-flow and heat-transfer within cellular copper structuresInternational Journal of Heat and Mass Transfer, 2004
- On the design of two-dimensional cellular metals for combined heat dissipation and structural load capacityInternational Journal of Heat and Mass Transfer, 2001
- Multifunctional microtruss laminates: Textile synthesis and propertiesJournal of Materials Research, 2001
- The topological design of multifunctional cellular metalsProgress in Materials Science, 2001
- On the young's moduli of Ti6Al4V alloysScripta Metallurgica et Materialia, 1993