Experimental and numerical analysis on the cutting force, cutting temperature, and tool wear of alloy steel (4340) during turning process
Open Access
- 1 November 2024
- journal article
- research article
- Published by AIP Publishing in AIP Advances
- Vol. 14 (11)
Abstract
This paper focuses primarily on the wear behavior observed in AISI4340 steel when machining with a multi-layered coated carbide tool. Numerical and experimental examination is processed out to predict the wear performance of AISI 4340 steel along with its cutting force and temperature. In this process, four layers of different coated material are bonded together to form a multi-layered coated carbide tool. The coated thickness is assessed with the assistance of a Scanning Electron Microscope (SEM). Experimental analysis takes place with a heavy duty lathe machine equipped with an infrared thermometer and force dynamometer. Simulation is performed using DEFORM-2D software to simulate cutting forces and interface temperature, and the output results obtained have been compared with the experimental work. With the help of the SEM image, maximum crater wear depth is evaluated and analyzed. Feed plays a crucial role in increasing the chip interface temperature and cutting force. For varied feed rates, the cutting tool edge radius, depth of cut, and cutting speed are taken as the input parameters. The proposed 2D finite element model provides effective parameter values for reducing wear. Results measured indicate that the output parameter values of interface temperature and cutting force obtained from simulation and experimental investigation match each other with high accuracy. Simulation results for temperature distribution around the tool tip show that a maximum temperature of 654 °C is formed at the feed rate of 0.4 mm/rev, leading to high heat flux. For the feed rate of 0.3 and 0.2 mm/rev, there is not much deviation in heat flux around the tool tip. The maximum temperature around the tool tip is near 527 °C for both 0.3 and 0.2 mm/rev. Simulation results show that the lowest tool wear of 0.001 23 mm was obtained for a feed rate of 0.2 mm/rev, followed by 0.004 25 (0.1 mm/rev), 0.005 09 mm (0.4 mm/rev), and 0.007 14 mm/rev.Keywords
Funding Information
- King Saud University (RSP2024R278)
This publication has 39 references indexed in Scilit:
- Prediction of Cutting Forces in Hard Turning Process Using Machine Learning Methods: A Case StudyJournal of Materials Engineering and Performance, 2023
- The relationship between adhesion morphology and cutting force in orthogonal cutting of 6061-T6 aluminum alloyThe International Journal of Advanced Manufacturing Technology, 2022
- Experimental investigation of different NN approaches for tool wear prediction based on vision system in turning of AISI 1045 steelInternational Journal on Interactive Design and Manufacturing (IJIDeM), 2022
- Exploring Deep Learning Methods to Forecast Mechanical Behavior of FSW Aluminum SheetsJournal of Materials Engineering and Performance, 2022
- Crater wear prediction in turning Ti6Al4V considering cutting temperature effectThe International Journal of Advanced Manufacturing Technology, 2022
- Development and implementation of crater and flank tool wear model for hard turning simulationsThe International Journal of Advanced Manufacturing Technology, 2022
- A parametric investigation of surface defect turning process: a simulation studySādhanā, 2021
- Real 3D turning simulation of materials with cylindrical shapes using ABAQUS/ExplicitJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2021
- Experimental studies of machining parameters on surface roughness, flank wear, cutting forces and work piece vibration in boring of AISI 4340 steels: modelling and optimization approachSN Applied Sciences, 2018
- Effect of textures on machining of Ti-6Al-4V alloy for coated and uncoated tools: A numerical comparisonThe International Journal of Advanced Manufacturing Technology, 2016