Wire-bonding on inkjet-printed silver pads reinforced by electroless plating for chip on flexible board packages
Authors:
- 1 September 2010
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Abstract
The nanoporous nature of the inkjet printed silver nanoparticles entail low hardness and surface effective contact area for being compatible with pads that are suitable for wire-bonding in electronic packaging. Electroless nickel plating is a selective metal deposition technique which can brings the required thickness and hardness for further pads processing. Here, a 1.7 μm thick nickel layer is deposited on top of 600 nm thick printed and sintered silver nanoparticles using Kapton polyimide as substrate. Prior to plating, a special attention was put on tuning microstructures of printed silver pads by sintering nanoparticles at various temperature ramps (0.1, 10 and 50°C/s) up to 200°C. Results show that fast sintering exhibits the lowest electrical resistivity which is suitable in printed interconnects. However, wire-bonding on nickel pads is best achieved when low sintering ramp is used. This slow sintering presents the highest adhesion strength at the nickel/silver interface since the pores dimensions were restricted to the nanoscale. The validation of the optimized bonding process came from the low electrical contact resistance between plated nickel and the bonded gold wire, and from the wire-pull test which is in accordance with the MIL-STD 883 standard. The actual results show that a compromise has to be found when emphasis is on patterning low resistive interconnects or stiff pads for wire-bonding applications. This compromise is tailored by the sintering engineering.Keywords
This publication has 16 references indexed in Scilit:
- Electrical sintering of nanoparticle structuresNanotechnology, 2008
- Mechanical characterization of solution-derived nanoparticle silver ink thin filmsJournal of Applied Physics, 2007
- Novel Monolayer-enhanced Non-Conductive Film (NCF) for Ultra-Fine Pitch High Performance Interconnect in Lead-free Electronics2007
- A simple guide to determine elastic properties of films on substrate from nanoindentation experimentsPhilosophical Magazine, 2006
- Mechanical properties of porous and fully dense low-κ dielectric thin films measured by means of nanoindentation and the plane-strain bulge test techniqueJournal of Materials Research, 2006
- Thermal behavior of silver nanoparticles for low-temperature interconnect applicationsJournal of Electronic Materials, 2005
- Small particle melting of pure metalsThin Solid Films, 1986
- A second report on sintering diagramsActa Metallurgica, 1981
- Size effect on the melting temperature of gold particlesPhysical Review A, 1976
- The size effect and the non-local Boltzmann transport equation in orifice and disk geometryProceedings of the Physical Society (1958-1967), 1966