Linearity-Enhanced Ring Amplifier Using Adaptive Slew-Rate Feed-Forward Path
- 31 March 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (12) , 2908-2912
Abstract
This paper presents a novel adaptive slew-rate ring amplifier. The proposed technique enhances the linearity, without stability degradation, using a rail-to-rail controlled feed-forward path used in parallel with the main ring amplifier. It offers additional degrees of freedom to improve the linearity/power consumption trade-off proposed in other reported slew-rate enhancement techniques. The proposed design has been implemented and simulated in a low-cost CMOS 65 nm technology. Operating from a single 0.9 V power supply, it consumes 186μA for switching frequency of 210MHz. For the same current consumption, it achieves an improvement of 10 dB in the total harmonic distortion (THD) compared to state-of-the-art.Keywords
This publication has 6 references indexed in Scilit:
- A 10-mW 16-b 15-MS/s Two-Step SAR ADC With 95-dB DR Using Dual-Deadzone Ring AmplifierIEEE Journal of Solid-State Circuits, 2019
- A Systematic Design Methodology for Class-AB-Style Ring AmplifiersIEEE Transactions on Circuits and Systems II: Express Briefs, 2018
- Passive Compensation for Improved Settling and Large Signal Stabilization of Ring Amplifiers2018
- An adaptive slew rate and dead zone ring amplifier2016
- A 100 MS/s, 10.5 Bit, 2.46 mW Comparator-Less Pipeline ADC Using Self-Biased Ring AmplifiersIEEE Journal of Solid-State Circuits, 2015
- Ring Amplifiers for Switched Capacitor CircuitsIEEE Journal of Solid-State Circuits, 2012