Ahmed Gharib Gadel-Karim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ahmed Gharib Gadel-Karim has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Ahmed Nader Mohieldin
Department of Electronics and Electrical Communications, Faculty of Engineering, Cairo University, Giza, 12613, Egypt
1 shared publication - Bao Huu Lam
Department of Electrical and Computer Engineering, University of California San Diego, La Jolla, CA, USA
1 shared publication Faisal Hussien
Electronics and Electrical Communications Engineering Department, Cairo University, Giza 12613, Egypt
1 shared publication- Hongyu Lu
Department of Electrical and Computer Engineering, University of California at San Diego, La Jolla, CA, USA
1 shared publication - Mohamed. M. Aboudina
Cairo University,Electronics and Electrical Communication Faculty of Engineering,Giza,Egypt
1 shared publication - Nader Sherif Kassem Fathy
Department of Electrical and Computer Engineering, University of California at San Diego, La Jolla, CA, USA
1 shared publication
Latest Publications
- 2 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 6, 5-8
A 0.11-mW 2.4-GHz Receiver Employing a Q-Boosted Impedance Transformer and Regenerative Amplifier Achieving −101-dBm Sensitivity and −28-dB SIR
This letter presents a 2.4 GHz OOK receiver that employs a Q-boosted impedance transformer and a regenerative amplifiers (RA) to provide high gain and sharp filtering prior to demodulation. A differential envelope detector (ED) is also used to increase the conversion gain further to help nullify the noise contribution of the subsequent baseband stages. Fabricated in 65 nm, the receiver achieves a sensitivity of -101 dBm at a data rate of 5 kbps, all while consuming 112 µW. The sharp RF filtering helps enable a signal-to-interference ratio (SIR) of -28 dB.
- 2 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 6, 5-8
A 0.11-mW 2.4-GHz Receiver Employing a Q-Boosted Impedance Transformer and Regenerative Amplifier Achieving −101-dBm Sensitivity and −28-dB SIR
This letter presents a 2.4 GHz OOK receiver that employs a Q-boosted impedance transformer and a regenerative amplifiers (RA) to provide high gain and sharp filtering prior to demodulation. A differential envelope detector (ED) is also used to increase the conversion gain further to help nullify the noise contribution of the subsequent baseband stages. Fabricated in 65 nm, the receiver achieves a sensitivity of -101 dBm at a data rate of 5 kbps, all while consuming 112 µW. The sharp RF filtering helps enable a signal-to-interference ratio (SIR) of -28 dB.
- 31 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (12) , 2908-2912
Linearity-Enhanced Ring Amplifier Using Adaptive Slew-Rate Feed-Forward Path
This paper presents a novel adaptive slew-rate ring amplifier. The proposed technique enhances the linearity, without stability degradation, using a rail-to-rail controlled feed-forward path used in parallel with the main ring amplifier. It offers additional degrees of freedom to improve the linearity/power consumption trade-off proposed in other reported slew-rate enhancement techniques. The proposed design has been implemented and simulated in a low-cost CMOS 65 nm technology. Operating from a single 0.9 V power supply, it consumes 186μA for switching frequency of 210MHz. For the same current consumption, it achieves an improvement of 10 dB in the total harmonic distortion (THD) compared to state-of-the-art.
- 31 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (12) , 2908-2912
Linearity-Enhanced Ring Amplifier Using Adaptive Slew-Rate Feed-Forward Path
This paper presents a novel adaptive slew-rate ring amplifier. The proposed technique enhances the linearity, without stability degradation, using a rail-to-rail controlled feed-forward path used in parallel with the main ring amplifier. It offers additional degrees of freedom to improve the linearity/power consumption trade-off proposed in other reported slew-rate enhancement techniques. The proposed design has been implemented and simulated in a low-cost CMOS 65 nm technology. Operating from a single 0.9 V power supply, it consumes 186μA for switching frequency of 210MHz. For the same current consumption, it achieves an improvement of 10 dB in the total harmonic distortion (THD) compared to state-of-the-art.