Abstract
Severe degradation of tribological performance and surface cavitation damage were frequently observed in water-lubricated bearings subjected to low-speed, heavy-load, and frequent start-stop operating conditions. To extend the service life and investigate the influence of substrate hardness and elastic modulus on coating performance, PI/PTFE coatings were prepared on CuPb22.5Sn2.5 copper alloy and 45# steel surfaces via liquid spraying. Furthermore, Molecular Dynamics (MD) simulations were employed to analyze the interfacial interactions, revealing that the shear deformation of polymer chains dominated the interfacial friction. Experimental results indicated that the copper-based coating exhibited superior tribological performance compared to the steel substrate due to higher H/E and H³/E² ratios under dry friction, reducing the coefficient of friction (CoF) and wear rate by 59.2% and 16.6%, respectively. Additionally, three-body abrasion and abrasive wear were effectively mitigated by the coating compared with the uncoated copper alloy, yielding significant decreases of 65.7% and 19.7% in CoF and wear rate. However, under seawater lubrication, tribological performance was primarily governed by the coupling effect between the coating’s mechanical properties and the lubrication environment. Consequently, the steel-based coating exhibited tribological performance comparable or superior to the copper-based system. Furthermore, in seawater cavitation experiments, the steel-based coating demonstrated the highest erosion resistance, reducing mass loss by 28.7% relative to the uncoated copper alloy, as its H³/E² value effectively withstood mechanical impacts. In summary, the tribological behavior and cavitation resistance were primarily governed by plastic deformation resistance (characterized by H/E and H³/E² ratios) and the material-medium coupling effect under specific lubrication conditions.

This publication has 42 references indexed in Scilit: