Simple and Scalable Synthesis of Vertically Aligned Anatase Nanowires for Enhanced Photoelectrochemical Performance
- 24 August 2020
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 3 (9) , 8317-8329
Abstract
Vertically-aligned 2.45 μm anatase nanowires were produced via a simple chemical bath deposition technique using a low-cost, easy to handle, water-soluble titanium salt precursor. The nanowires were grown from the substrate surface as layered titanate, and then converted to anatase by calcination. The factors controlling nanowire growth and performance, such as the concentration of HNO3, the amount of H2O2, melamine and urea, are discussed. It was found that an increase in the concentration of HNO3 could result in a slow rate of hydrolysis which would effectively reduce homogeneous nucleation in the solution and promote heterogeneous nucleation on the substrate surface, resulting in the growth of long nanowires (i.e., 2.45 μm). It was also noted that an increasing concentration of HNO3 resulted in a slight decrease in the nanowire diameter from 62 nm to 52 nm due to the adsorption of NO3- onto certain facets of the nanowires, which promotes anisotropic growth. In addition, H2O2, melamine and urea were also found to play important roles in the growth of nanowires. As a representative application, the as-developed TiO2 nanowires were explored as a photoanode, which demonstrated considerably enhanced photoelectrochemical performance compared to the rutile nanorods and P25 TiO2.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada
This publication has 66 references indexed in Scilit:
- Resolving surface chemical states in XPS analysis of first row transition metals, oxides and hydroxides: Cr, Mn, Fe, Co and NiApplied Surface Science, 2011
- Growth of Oriented Single-Crystalline Rutile TiO2 Nanorods on Transparent Conducting Substrates for Dye-Sensitized Solar CellsJournal of the American Chemical Society, 2009
- Importance of the band gap energy and flat band potential for application of modified TiO2 photoanodes in water photolysisJournal of Power Sources, 2008
- Surface-modified anodic TiO2 films for visible light photocurrent responseElectrochemistry Communications, 2007
- Distinctive structural features of hydroxyamino-1,3,5-triazine ligands leading to enhanced hydrolytic stability of their titanium complexesDalton Transactions, 2006
- Synthesis of shape-controlled titania particles from a precursor solution containing ureaMaterials Letters, 2004
- Photocatalytic degradation of a cyanuric acid, a recalcitrant speciesJournal of Photochemistry and Photobiology A: Chemistry, 2004
- Evolution of toxicity during melamine photocatalysis with TiO2 suspensionsJournal of Photochemistry and Photobiology A: Chemistry, 2004
- Daylight Photocatalysis by Carbon‐Modified Titanium DioxideAngewandte Chemie International Edition, 2003
- Kinetic approach to the photocurrent transients in water photoelectrolysis at n-titanium dioxide electrodes. 1. Analysis of the ratio of the instantaneous to steady-state photocurrentThe Journal of Physical Chemistry, 1985