Dynamic Spatial Programming of Active–Active Antagonistic Fiber Architectures for Enhanced Morphing
- 14 November 2026
- journal article
- Published by Wiley in Advanced Materials
Abstract
Programming multiple deformation modes within a continuous liquid crystal elastomer (LCE) filament remains challenging because molecular alignment and active‐material distribution are typically coupled to the external printing path. Here, a rotational multimaterial printing strategy is introduced that encodes two co‐curable LCE phases with opposite free thermal strains within individual fibers. These antagonistic free strains act cooperatively after co‐curing to generate internal strain mismatch and structural deformation. A dual‐channel rotating nozzle co‐extrudes a thermally contracting nematic LCE and a thermally elongating smectic LCE, while nozzle angle, angular velocity, and flow‐rate ratio prescribe their cross‐sectional and axial distributions. Discrete and continuous rotation enable contraction, elongation, in‐plane bending, out‐of‐plane curling, and helical coiling without changing the filament centerline. Under matched conditions, the active–active fibers exhibit an approximately 1.6‐fold increase in curvature relative to the active–passive controls, while simultaneous co‐curing increases interfacial peel strength by approximately 30 times that achieved by sequential curing. The same encoding strategy extends from individual fibers to grids and Gaussian‐curvature surfaces and enables force‐generating strips, thermal protection, self‐sensing, particle sorting, and adaptive gripping. Rotational multimaterial printing therefore decouples intra‐filament architecture from toolpath geometry and provides a general route to spatially programmable active fibers.Funding Information
- National Natural Science Foundation of China (52675528)
- Fundamental Research Funds for the Central Universities (YD2090002019)
- Fundamental Research Funds for the Central Universities (YD2090002022)
This publication has 32 references indexed in Scilit:
- Spatially Hierarchical Gradient Orientation of Liquid Crystal Gels for Antagonistic Cooperative ActuationAngewandte Chemie International Edition, 2026
- Porous Hybrid Soft Actuators From Liquid Crystal Networks and Lyotropic Chromonic Liquid Crystal Templated HydrogelsAdvanced Materials, 2026
- Rotational Multimaterial 3D Printing of Soft Robotic Matter With Embedded Asymmetrical PneumaticsAdvanced Materials, 2025
- Wearable and Implantable Soft RobotsChemical Reviews, 2024
- Multimodal Soft Robotic Actuation and LocomotionAdvanced Materials, 2024
- A 3D‐Printed Ferromagnetic Liquid Crystal Elastomer with Programmed Dual‐Anisotropy and Multi‐ResponsivenessAdvanced Materials, 2023
- 4D Printing of Freestanding Liquid Crystal Elastomers via Hybrid Additive ManufacturingAdvanced Materials, 2022
- Digital Programming of Liquid Crystal Elastomers to Achieve High-Fidelity Surface MorphingApplied Materials Today, 2022
- Polarization Dependent Light‐Driven Liquid Crystal Elastomer Actuators Based on Photothermal EffectAdvanced Optical Materials, 2020
- 3D Printing of Liquid Crystal Elastomeric Actuators with Spatially Programed Nematic OrderAdvanced Materials, 2018