Numerical Analysis of Hydroinertia Gas Bearings with Inclined Supply Holes for High-Speed Rotary Machines
Open Access
- 11 September 2014
- journal article
- Published by Science Publishing Group in International Journal of Mechanical Engineering and Applications
- Vol. 2 (4) , 52-57
Abstract
Hydroinertia gas journal bearings have been applied to solid-state nuclear magnetic resonance (NMR) as an example. This type of bearing can realize a stable operation for the ultra-high-speed rotation of an NMR sample tube as high as several million rpm, because these bearings utilize a large radial clearance compared with conventional externally pressurized bearings. To obtain even higher rotational speeds, inclined supply holes in the direction of shaft rotation have been proposed. The characteristics of these proposed bearings are examined in this study by numerical analysis because the actual NMR sample rotor is thin and long (with a diameter of 1 mm to 4 mm). The numerical analysis results of the hydroinertia journal bearings are reported in this study. Variation of the pressure distribution and the load capacity with respect to the effect of the radial clearance and the angle of the supply holes are described. The results show that a negative pressure is generated at large radial clearance, and the load capacity does not affect the angle. The pressure distribution was experimentally verified using a test rig, which has 10 mm diameter rotor.Keywords
This publication has 10 references indexed in Scilit:
- 1302 Calculation of the Characteristics and its Verification of the Hydroinertia Gas Bearings with Inclined Supply HolesThe Proceedings of the Machine Design and Tribology Division meeting in JSME, 2012
- Very fast magic angle spinning 1H-14N 2D solid-state NMR: Sub-micro-liter sample data collection in a few minutesJournal of Magnetic Resonance, 2011
- Hydroinertia Gas Bearing System to Achieve 470m∕s Tip Speed of 10mm-Diameter ImpellersJournal of Tribology, 2007
- Numerical Calculations of Pressure Distribution in the Bearing Clearance of Circular Aerostatic Thrust Bearings With a Single Air Supply InletJournal of Tribology, 2006
- Development of high-speed micro-gas bearings for three-dimensional micro-turbo machinesJournal of Micromechanics and Microengineering, 2005
- Hydroinertia gas bearings for micro spinnersJournal of Micromechanics and Microengineering, 2005
- Analytical and Experimental Study of Hydroinertia Gas Bearings for Micromachine Gas Turbines2005
- Turbo test rig with hydroinertia air bearings for a palmtop gas turbineJournal of Micromechanics and Microengineering, 2004
- Rotordynamics of Gas-Lubricated Journal Bearing Systems1999
- A Study on Run-out Characteristics of Externally Pressurized Gas Journal Bearing. 1st Report. Modified DF Method for Point-Source Solution.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C, 1992