Development of Filter Composites Based on Eucalyptus Cellulosic Nanofibers, Sugarcane Bagasse Fibers and Soybean Hulls Applied in Biodiesel Purification
Open Access
- 1 January 2025
- journal article
- Published by Tech Science Press in Journal of Renewable Materials
- Vol. 13 (5) , 957-980
Abstract
Alternative methods for biodiesel purification that focus on ease of operation, cost reduction, and elimination of contaminated residues or that are easier to treat have received more attention. The dry wash route was used as an alternative to the wet route in biodiesel production. Filter membranes were developed based on cellulose nanofibers as the matrix and sugarcane bagasse fibers or soy hulls, as reinforcement to the matrix, before and after two chemical treatments (carboxymethylation and regeneration with sulfuric acid). The filters were characterized by permeability capacity, morphology, wettability, porosity, SEM and mechanical properties. The filtered biodiesel was also completely characterized. One of the major impacts of dry purification of biodiesel was the glycerin content after filtration. The filters CNFBR 20–28, CNFSR 5–28, CNFSR 5–35, and CNFBC 5–28 produced purified biodiesel with glycerin content below 0.02% (200 mg/L). Another relevant fact is related to the best results for acidity index, combined alkalinity, and glycerin content, obtained by the regenerated filter CNFBR 20–28, which presented a considerable permeate flow rate value above 4145 L h−1 m−2, which can be related to compacted lamellar layers observed by SEM. The produced filters were applied to biodiesel purification using a low-pressure filtration system and a simple vacuum pump, which resulted in an appreciable reduction in cost. The produced filter with sugarcane bagasse fiber carboxymethylated at 28 mesh of granulometry was efficient for biodiesel purification, including the efficient removal of free glycerin, in agreement with the standards defined by the national controlling agencies.Keywords
This publication has 52 references indexed in Scilit:
- Extraction of nanocellulose from sugarcane bagasse and its characterization for potential applicationsPolymer Composites, 2021
- Bioenergy potential and thermochemical characterization of lignocellulosic biomass residues available in PakistanKorean Journal of Chemical Engineering, 2020
- Imaging and spectroscopic techniques for microstructural and compositional analysis of lignocellulosic materials: a reviewBiomass Conversion and Biorefinery, 2020
- First report on fabrication and characterization of soybean hull fiber: polymer composite filaments for fused filament fabricationProgress in Additive Manufacturing, 2020
- Hydrophobic nano-bamboo fiber-reinforced acrylonitrile butadiene styrene electrospun membrane for the filtration of crude biodieselApplied Nanoscience, 2019
- Eucalyptus pulp as an adsorbent for biodiesel purificationCellulose, 2015
- Titrimetric methods for the determination of surface and total charge of functionalized nanofibrillated/microfibrillated cellulose (NFC/MFC)Cellulose, 2013
- Determination of dissociable groups in natural and regenerated cellulose fibers by different titration methodsJournal of Applied Polymer Science, 2004
- About the surface characteristics of natural fibresMacromolecular Materials and Engineering, 2000
- Influence of the surface chemistry on the wettability of stainless steelSurface and Interface Analysis, 1994