Study on Binder Film Thickness Distribution of Recycled Asphalt Pavements
- 16 December 2019
- journal article
- research article
- Published by ASTM International in Journal of Testing and Evaluation
- Vol. 48 (3) , 2474-2493
Abstract
Binder film thickness (BFT) plays a vital role during the design of asphalt mixture and fine aggregate matrix because BFT can exert a significant effect on the performance of asphalt materials. However, the surface area factors are affected by the different specific gravities of the aggregates, which are always ignored during the calculation of BFT. Moreover, whether the BFT is uniformly distributed in asphalt mixture is controversial. Hence, it is necessary to further study the distribution of asphalt film thickness in asphalt materials and its influence factor. This study analyzed the distribution of BFT in coarse and fine parts of recycled asphalt pavements (RAPs). Firstly, a part of four types of RAP (Teichert, Syar, Vulcan coarse, and Vulcan fine) were sieved by #8 sieve (2.36 mm) to achieve coarse and fine parts of RAP. Secondly, the binder content and aggregate gradation were investigated through the ignition and extraction method. Thirdly, surface area ratio was used to evaluate the influence of the ignition and extraction method on the surface area of aggregate sieved from RAP. Finally, the BFT of different types of RAP were calculated through two different methods to evaluate the effect of specific gravities of the aggregates on BFT. The results indicate that for the coefficient of variation, 30 out of 32 data were less than 15.0 %, which implies the BFT was almost evenly distributed in coarse and fine parts of RAP. In addition, the difference of surface area factors caused by the different specific gravities of the aggregates exerts negligible influence on the surface area and the calculation of BFT.Keywords
This publication has 21 references indexed in Scilit:
- Influence of crumb rubber and tafpack super on performances of SBS modified porous asphalt mixturesRoad Materials and Pavement Design, 2019
- Performance enhancement of porous asphalt pavement using red mud as alternative fillerConstruction and Building Materials, 2018
- Comparative evaluation of hot-mix asphalt design methodsInternational Journal of Pavement Engineering, 2012
- Characterization of OGFC Mixtures Containing Reclaimed Polyethylene FibersJournal of Materials in Civil Engineering, 2011
- Investigation of In-Place Asphalt Film Thickness and Performance of Hot-Mix Asphalt MixturesJournal of Materials in Civil Engineering, 2009
- Validity of Asphalt Binder Film Thickness Concept in Hot-Mix AsphaltTransportation Research Record: Journal of the Transportation Research Board, 2008
- Mixture Design of Fire-Retarded OGFC in Road TunnelRoad Materials and Pavement Design, 2005
- Critical Review of Voids in Mineral Aggregate Requirements in SuperpaveTransportation Research Record: Journal of the Transportation Research Board, 1998
- Minimum Voids in Mineral Aggregate in Hot-Mix Asphalt Based on Gradation and Volumetric PropertiesTransportation Research Record: Journal of the Transportation Research Board, 1996
- Effect of Asphalt Film Thickness on Short- and Long-Term Aging of Asphalt Paving MixturesTransportation Research Record: Journal of the Transportation Research Board, 1996