Using injected additive materials to improve pipeline transportation in real-world experiments and computational fluid dynamics
Open Access
- 1 January 2024
- journal article
- research article
- Published by Yildiz Technical University in Journal of Thermal Engineering
- Vol. 10 (4) , 826-835
Abstract
In this paper, an experiment has been conducted where additive materials have been added to heavy crude oil to improve transportation. This is done on a pipeline length of 186 km. During the experiment, materials will be added to the inner pipeline to lubricate the heavy crude oil fiber and reduce the pressure drop. The additive materials, which are Drag-Reducing Agents (DRAs) (These are polymers that reduce the friction between the crude oil and the pipeline walls) are injected into heavy crude oil at different doses (two materials); the doses are 4, 6, 8, 10, and 12. A comparison between the cases before and after this additive has been obtained in the pipeline for velocity magnitude, vorticity magnitude, pressure drop, and wall shear stress. It can be observed that doses (8, 10, and 12) obtained a wide range of flow rates with fewer pressure drops than other dose points. The pressure at the city of Al-Faw has been found, and the maximum values are 1.482, 1.413, and 1.399 MPa for doses 12, 8, and 6, respectively. The simulation was done with COMSOL 5.4 Multiphasic software. Flow ranges increase as the dose increases. Shear stress increases with mass injection rate. Transporting heavy crude oil long distances is easier with additive materials. After the additive materials are added, crude oil will be transported for a long time without pressure drops, increasing the flow rate. The two turbines pump heavy crude oil through a 48 inches wide and 186 km long pipeline. These pipelines transfer heavy crude oil from the refinery to Al-Faw City.Keywords
This publication has 17 references indexed in Scilit:
- CFD investigation on characteristics of heavy crude oil flow through a horizontal pipeEgyptian Journal of Petroleum, 2021
- Characterization of interfacial waves and pressure drop in horizontal oil-water core-annular flowsPhysics of Fluids, 2017
- Energy analysis of oil-water flow with drag-reducing polymer in different pipe inclinations and diametersJournal of Petroleum Science and Engineering, 2017
- Influence of Radial Flux Inflow Profile on Pressure Drop of Perforated Horizontal WellboreJournal of Energy Resources Technology, 2014
- A review of technologies for transporting heavy crude oil and bitumen via pipelinesJournal of Petroleum Exploration and Production Technology, 2013
- Pipeline transportation of viscous crudes as concentrated oil-in-water emulsionsJournal of Petroleum Science and Engineering, 2012
- Transportation of heavy and extra-heavy crude oil by pipeline: A reviewJournal of Petroleum Science and Engineering, 2011
- Cement-lined pipes for water lubricated transport of heavy oilInternational Journal of Multiphase Flow, 1996
- Friction factor and holdup studies for lubricated pipelining—I. Experiments and correlationsInternational Journal of Multiphase Flow, 1993
- A theoretical model for core-annular flow of a very viscous oil core and a water annulus through a horizontal pipeInternational Journal of Multiphase Flow, 1983