Highlighting the implications of selenium dispersion from disposal of Kahota Industrial Triangle area, Islamabad, Pakistan using three-dimension solute transport model
- 11 July 2009
- journal article
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 167 (1-4) , 565-579
Abstract
This study highlights the implications of selenium (Se) dispersion in groundwater flow regimes of Kahota Industrial Triangle area located adjacent to the Soan River, Islamabad. Initially, a regional groundwater 3-D flow model has been developed, calibrated to the known observed heads of 24 water wells, verified, and confirmed that convergence has actually arrived to satisfy the steady state condition. Later, the transient simulation was carried out adding in the known recharge, storage factor, porosity, and observed drawdown matched with the simulated drawdown that appears to fall in close agreement with a difference of 0.25 m. As such the steady state groundwater model has facilitated to understand the mechanism of groundwater flow regimes in reference to the implications of selenium dispersion from disposal of Kahota Industrial Triangle area. Thirty-five water samples were collected mainly from the industrial water wells for the evaluation of heavy metals. Selenium being the major contributor of pollution has been short listed to monitor its dispersion using a solute transport model modular three-dimensional transport model (MT3D). Chemical parameters related to selenium characteristics including horizontal and vertical transverse dispersivity/longitudinal dispersivity, effective molecular diffusion coefficient and bulk density of the porous medium of aquifers have been used in MT3D contaminant transport model. MT3D is run for 30 years in steady state condition. As usual first run did not produce the exact field conditions. Therefore, the contaminant transport model is calibrated against the 32 values of observed selenium concentrations in boreholes by minor adjustments in the chemical parameter values. The final calibration has been achieved with residual value of 3.88 × 10 − 5 Kg/m3. Seven hypothetical observation wells are used to monitor the selenium concentrations over a long-term period of time.Keywords
This publication has 26 references indexed in Scilit:
- Implications of depletion of groundwater levels in three layered aquifers and its management to optimize the supply demand in the urban settlement near Kahota Industrial Triangle area, Islamabad, PakistanEnvironmental Monitoring and Assessment, 2009
- Kinetic dissolution of carbonates and Mn oxides in acidic water: measurement of in situ field rates and reactive transport modelingApplied Geochemistry, 2003
- Capture zone, travel time, and solute-transport predictions using inverse modeling and different geological modelsHydrogeology Journal, 2003
- A Dupuit formulation for modeling seawater intrusion in regional aquifer systemsWater Resources Research, 2003
- MODFLOW/MT3DMS‐Based Reactive Multicomponent Transport ModelingGroundwater, 2003
- Implications of Observed and Simulated Ambient Flow in Monitoring WellsGroundwater, 2001
- A Comparison of Solute‐Transport Solution Techniques and Their Effect on Sensitivity Analysis and Inverse Modeling ResultsGroundwater, 2001
- Modeling the Effect of Chemical Fertilizers on Ground Water Quality in the Nile Valley Aquifer, EgyptGroundwater, 2001
- Identifying Potential Land Use‐Derived Solute Sources to Stream Baseflow Using Ground Water Models and GISGroundwater, 2001
- Toxicology of selenium: A reviewClinical Toxicology, 1980