Zulfiqar Ahmad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Zulfiqar Ahmad has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Arshad Ashraf
Climate, Energy and Water Research Institute, National Agricultural Research Centre (NARC), Islamabad, Pakistan
4 shared publications - Gulraiz Akhter
Department of Earth Sciences, Quaid-i-Azam University, Islamabad, Pakistan
4 shared publications - Alan Fryar
Department of Earth and Environmental Sciences University of Kentucky Lexington KY 40506
3 shared publications - Iftekhar Ahmed
National College of Business Administration and Economics, Lahore, Pakistan
3 shared publications - Rubina Kausar
Quaid-I-Azam University
3 shared publications Muhammad Fahad Mahmood
Department of Earth Sciences, Quaid-i-Azam University, Islamabad, Pakistan
2 shared publications
Latest Publications
- Open Access
- 29 October 2025
- Published by IntechOpen
Comparative Analysis of Aquifer Properties in Alluvial and Potwar Regions through Pumping Test Interpretation
Overall, there is ample variability in Punjab (Lower Indus Basin) and Potwar Aquifers (Upper Indus Basin), Pakistan, in terms of their hydraulic characteristics and yielding capabilities with longer time pumping durations. Alluvial aquifers tend to be considered of longer thicknesses and may have one length of screen with an appropriate slot opening for fine-medium-coarse (FMC) sand, while in Potwar aquifers, several screens of variable lengths with variable slot openings for boulder, gravels, and sandstone may be used. Data were collected from representative wells in each region (Punjab and Potwar), with four-step draw tests each of 120 minutes duration, along with a rate of discharge varying from 40 to 90 m3/sec. Likewise, constant-rate pump testing of 60 m3/hr was carried out for 72 hrs (static level 8.14 m), with a drawdown of 3.149 m. The recovery test took 8 hours to draw up the water level to its original static level. Interpretation of the time-drawdown data was made using established analytical methods such as the Theis solution, Cooper-Jacob straight-line method, and recovery test analysis. Results show that alluvial aquifers, consisting of unconsolidated sand and gravel, display high transmissivity and hydraulic conductivity, indicating favorable conditions for high-yield groundwater extraction. Conversely, the Potwar aquifers, composed of semi-consolidated sandstone and shale interbeds, exhibit significantly lower permeability and storativity, reflecting confined to semi-confined conditions with limited recharge capacity. Well loss computed at 60 m3/h is 0.22 m; aquifer loss is 2.68 m, and well efficiency by Hantush and Bierschenk method is 93%. Estimated transmissivity (m2/day) is 1914.
- 29 October 2025
- Published by IntechOpen
Open AccessComparative Analysis of Aquifer Properties in Alluvial and Potwar Regions through Pumping Test Interpretation
Overall, there is ample variability in Punjab (Lower Indus Basin) and Potwar Aquifers (Upper Indus Basin), Pakistan, in terms of their hydraulic characteristics and yielding capabilities with longer time pumping durations. Alluvial aquifers tend to be considered of longer thicknesses and may have one length of screen with an appropriate slot opening for fine-medium-coarse (FMC) sand, while in Potwar aquifers, several screens of variable lengths with variable slot openings for boulder, gravels, and sandstone may be used. Data were collected from representative wells in each region (Punjab and Potwar), with four-step draw tests each of 120 minutes duration, along with a rate of discharge varying from 40 to 90 m3/sec. Likewise, constant-rate pump testing of 60 m3/hr was carried out for 72 hrs (static level 8.14 m), with a drawdown of 3.149 m. The recovery test took 8 hours to draw up the water level to its original static level. Interpretation of the time-drawdown data was made using established analytical methods such as the Theis solution, Cooper-Jacob straight-line method, and recovery test analysis. Results show that alluvial aquifers, consisting of unconsolidated sand and gravel, display high transmissivity and hydraulic conductivity, indicating favorable conditions for high-yield groundwater extraction. Conversely, the Potwar aquifers, composed of semi-consolidated sandstone and shale interbeds, exhibit significantly lower permeability and storativity, reflecting confined to semi-confined conditions with limited recharge capacity. Well loss computed at 60 m3/h is 0.22 m; aquifer loss is 2.68 m, and well efficiency by Hantush and Bierschenk method is 93%. Estimated transmissivity (m2/day) is 1914.
- Open Access
- 28 March 2024
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 14 (6) , 1349-1364
Assessing the hydrocarbon potential of the Kadanwari gas field using integrated seismic and petrophysical data
Kadanwari is a major gas-producing field in Pakistan's Lower Indus Basin (LIB), extensively explored for optimized production. However, the reservoir sands of the Lower Goru Formation (LGF), deposited in a complex river-dominated delta, bear severe variability and hinder accurate facies approximation for optimal production. Furthermore, the regionally extended NNW-SSE directed horst and graben structures significantly compartmentalized these reservoir facies. The main E-sand interval is analyzed for its geological properties, depositional environment, and distribution. The integration of various approaches, including seismic interpretation, attribute extraction, well-based facies modeling, and petrophysical evaluation, proved significant in evaluating the heterogeneous and tectonically influenced E-sands. The discontinuity attribute substantially highlighted the structural style and aided in analyzing the geometries of faults. The low values of the frequency attribute (< 10 Hz) signified the entrapped gas-bearing sands along the faulted zones. The high responses of instantaneous amplitude and sweetness profoundly illuminated the gas-significant deposits throughout the field in association with the well-identified gas-prone sand facies. The outcomes of the neutron-density crossplot depicted gas-bearing sands having low density (< 2.3 g/cc) and good porosity (12%) with the assessment of various cements. The facies modeling distinguished between clean and intermixed sand-shale reservoir zones. Petrophysical analysis revealed a net pay of 14 m within E-sand having gas saturation of about 68%. The adopted approach is robust and efficient, employing a limited data set for developing well-associated seismic responses for potential zone delineation within structural arrangements. The techniques can be optimistic about the LGF's complex potential sands demarcation throughout the Indus Basin.
- 28 March 2024
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 14 (6) , 1349-1364
Open AccessAssessing the hydrocarbon potential of the Kadanwari gas field using integrated seismic and petrophysical data
Kadanwari is a major gas-producing field in Pakistan's Lower Indus Basin (LIB), extensively explored for optimized production. However, the reservoir sands of the Lower Goru Formation (LGF), deposited in a complex river-dominated delta, bear severe variability and hinder accurate facies approximation for optimal production. Furthermore, the regionally extended NNW-SSE directed horst and graben structures significantly compartmentalized these reservoir facies. The main E-sand interval is analyzed for its geological properties, depositional environment, and distribution. The integration of various approaches, including seismic interpretation, attribute extraction, well-based facies modeling, and petrophysical evaluation, proved significant in evaluating the heterogeneous and tectonically influenced E-sands. The discontinuity attribute substantially highlighted the structural style and aided in analyzing the geometries of faults. The low values of the frequency attribute (< 10 Hz) signified the entrapped gas-bearing sands along the faulted zones. The high responses of instantaneous amplitude and sweetness profoundly illuminated the gas-significant deposits throughout the field in association with the well-identified gas-prone sand facies. The outcomes of the neutron-density crossplot depicted gas-bearing sands having low density (< 2.3 g/cc) and good porosity (12%) with the assessment of various cements. The facies modeling distinguished between clean and intermixed sand-shale reservoir zones. Petrophysical analysis revealed a net pay of 14 m within E-sand having gas saturation of about 68%. The adopted approach is robust and efficient, employing a limited data set for developing well-associated seismic responses for potential zone delineation within structural arrangements. The techniques can be optimistic about the LGF's complex potential sands demarcation throughout the Indus Basin.
- 1 April 2021
- Published by Elsevier in Journal of Natural Gas Science and Engineering
- Vol. 88, 103833
Corrigendum to total organic carbon content and total porosity estimation in unconventional resource play using integrated approach through seismic inversion and well logs analysis within the Talhar Shale, Pakistan [Journal of Natural Gas science and Engineering, volume 52C, 2019, 2423]
- 1 April 2021
- Published by Elsevier in Journal of Natural Gas Science and Engineering
- Vol. 88, 103833
Corrigendum to total organic carbon content and total porosity estimation in unconventional resource play using integrated approach through seismic inversion and well logs analysis within the Talhar Shale, Pakistan [Journal of Natural Gas science and Engineering, volume 52C, 2019, 2423]
- 23 October 2019
- Published by Springer Nature in Earth Systems and Environment
- Vol. 3 (3) , 613-623
Environmental Study of Water Reservoirs for the Watershed Management in Pakistan
- 23 October 2019
- Published by Springer Nature in Earth Systems and Environment
- Vol. 3 (3) , 613-623
Environmental Study of Water Reservoirs for the Watershed Management in Pakistan
- Open Access
- 30 March 2017
- Published by Pakistan Atomic Energy Commission in The Nucleus
- Vol. 54 (1) , 10-15
Application of Multi-Layer Feed Forward Neural Network (MLFNN) for the
The geophysical formation evaluation plays a fundamental role in hydrocarbon exploration. Porosity is one of the main parameters that determine the amount of oil present in a rock formation. Accurate determination of porosity is a difficult problem due to failure in understanding of spatial porosity parameter distribution. Multi-layer feed forward neural network (MLFN) proved to be a powerful tool for mapping porosity across the whole field and proved to be a powerful tool for mapping complicated relationships in reservoir. In MLFN three layers are involved that is an input layer, an output layer and a variable number of hidden layers. Input for training eight external attributes are used which are P-impedance, S-impedance, density, fluid, lithology impedance, lamda-rho, mu-rho, and Vp/Vs. Five nodes are used in hidden layer and one output node for mapping total porosity of Badin gas field. In this study 3D cube of Badin field and 3 wells are used. The findings proved competence of multi-layer feed forward neural network in the porosity prediction process with an average error of 0.014 [v/v] and the correlation coefficient of 0.91 and helped in studying the lateral variations in the porosity along the reservoir. The A sands show same porosity values along both the well locations, while for B sand the porosity value decreases from Zaur-01 to Chakri-01 well while for C sand the porosity value increases from Zaur-01 to Chakri-01 well.
- 30 March 2017
- Published by Pakistan Atomic Energy Commission in The Nucleus
- Vol. 54 (1) , 10-15
Open AccessApplication of Multi-Layer Feed Forward Neural Network (MLFNN) for the
The geophysical formation evaluation plays a fundamental role in hydrocarbon exploration. Porosity is one of the main parameters that determine the amount of oil present in a rock formation. Accurate determination of porosity is a difficult problem due to failure in understanding of spatial porosity parameter distribution. Multi-layer feed forward neural network (MLFN) proved to be a powerful tool for mapping porosity across the whole field and proved to be a powerful tool for mapping complicated relationships in reservoir. In MLFN three layers are involved that is an input layer, an output layer and a variable number of hidden layers. Input for training eight external attributes are used which are P-impedance, S-impedance, density, fluid, lithology impedance, lamda-rho, mu-rho, and Vp/Vs. Five nodes are used in hidden layer and one output node for mapping total porosity of Badin gas field. In this study 3D cube of Badin field and 3 wells are used. The findings proved competence of multi-layer feed forward neural network in the porosity prediction process with an average error of 0.014 [v/v] and the correlation coefficient of 0.91 and helped in studying the lateral variations in the porosity along the reservoir. The A sands show same porosity values along both the well locations, while for B sand the porosity value decreases from Zaur-01 to Chakri-01 well while for C sand the porosity value increases from Zaur-01 to Chakri-01 well.
- 1 September 2016
- Published by Elsevier in Journal of Applied Geophysics
- Vol. 132, 174-183
Changes in gravitational parameters inferred from time variable GRACE data—A case study for October 2005 Kashmir earthquake
- 1 September 2016
- Published by Elsevier in Journal of Applied Geophysics
- Vol. 132, 174-183
Changes in gravitational parameters inferred from time variable GRACE data—A case study for October 2005 Kashmir earthquake
- Open Access
- 27 July 2016
- Published by IntechOpen
Appraisal of Groundwater Flow Simulation in the Sub- Himalayan Watershed of Pakistan
Appraisal of Groundwater Flow Simulation in the Sub- Himalayan Watershed of Pakistan | InTechOpen, Published on: 2016-07-27. Authors: Zulfiqar Ahmad, Arshad Ashraf and Mohsin Hafeez
- 27 July 2016
- Published by IntechOpen
Open AccessAppraisal of Groundwater Flow Simulation in the Sub- Himalayan Watershed of Pakistan
Appraisal of Groundwater Flow Simulation in the Sub- Himalayan Watershed of Pakistan | InTechOpen, Published on: 2016-07-27. Authors: Zulfiqar Ahmad, Arshad Ashraf and Mohsin Hafeez
- 16 February 2016
- Published by Springer Nature in Surveys in Geophysics
- Vol. 37 (3) , 579-599
Geomorphology of the Alluvial Sediments and Bedrock in an Intermontane Basin: Application of Variogram Modeling to Electrical Resistivity Soundings
- 16 February 2016
- Published by Springer Nature in Surveys in Geophysics
- Vol. 37 (3) , 579-599
Geomorphology of the Alluvial Sediments and Bedrock in an Intermontane Basin: Application of Variogram Modeling to Electrical Resistivity Soundings
- 1 July 2015
- Published by Springer Nature in Journal of Mountain Science
- Vol. 12 (4) , 972-982
Hydrological response to environment change in Himalayan watersheds: Assessment from integrated modeling approach
- 1 July 2015
- Published by Springer Nature in Journal of Mountain Science
- Vol. 12 (4) , 972-982
Hydrological response to environment change in Himalayan watersheds: Assessment from integrated modeling approach