Investigation on Microstructure and Compressive Strength of Brazing Porous Nickel to Copper and Stainless Steel
Open Access
- 25 September 2023
- journal article
- research article
- Published by SciCell in Acta Metallurgica Slovaca
- Vol. 29 (3) , 148-154
Abstract
This paper investigates the effects of brazing temperatures on the microstructure and compressive strength for brazing porous nickel to copper and stainless steel using VZ2250 as the brazing filler metal. A high vacuum furnace is used to braze the samples. Three different brazing process parameters were set with a heating and cooling rate of 10°C/min, respectively. The characteristics of the joint interface have been investigated to evaluate the performance of the brazed samples by use of scanning electron microscope, energy-dispersive X-Ray spectroscope, X-Ray diffractometer, and Instron Universal Testing machine. The data obtained has been quantitively analyzed to confirm the diffusion of the BFM during the brazing process. It has been found that the diffusion process resulted in an increase in the rigidity of the porous Ni. The compressive strength tests for the brazed joint showed that the maximum compressive strength can be achieved for brazing at 680°C. The highest compressive strength value has been justified by quantitative analysis of the microstructural data. It has been proved that the VZ2250 BFM effectively diffused into the porous Ni at the brazing temperature of 680°C; Cu3P and Cu6Sn5 were detected at the brazed Interface 1, whereas MnNi3 phase at the brazed Interface 2.Keywords
This publication has 14 references indexed in Scilit:
- Formation mechanism of interfacial microstructures and mechanical properties of Ti2AlNb/Ni-based superalloy joints brazed with NiCrFeSiB filler metalProgress in Natural Science: Materials International, 2021
- Applying plate heat exchangers in crude preheat train for fouling mitigationChemical Engineering Research and Design, 2021
- The use of porous metals in heat exchangersIOP Conference Series: Materials Science and Engineering, 2020
- Laser brazing of a dissimilar joint of austenitic stainless steel and pure copperWelding International, 2015
- Identification of the Critical Pore Sizes in Sintered and Ecaped Aluminium 6XXX AlloyArchives of Metallurgy and Materials, 2013
- Microstructural Characteristics of a Stainless Steel/Copper Dissimilar Joint Made by Laser WeldingMetallurgical and Materials Transactions A, 2013
- Elastic properties of antiperovskite-type Ni-rich nitrides MNNi3 (M=Zn, Cd, Mg, Al, Ga, In, Sn, Sb, Pd, Cu, Ag and Pt) as predicted from first-principles calculationsPhysica B: Condensed Matter, 2010
- Microstructure of nickel foam/Mg double interpenetrating compositesTransactions of Nonferrous Metals Society of China, 2010
- Diffusion bonding of 410 stainless steel to copper using a nickel interlayerMaterials Characterization, 2010
- The use of plate heat exchangers to improve energy efficiency in phosphoric acid productionJournal of Cleaner Production, 2009