Experimental and Numerical Study on Local Buckling Analysis of Q550 High-Strength Steel T-Rib-Stiffened Plates
Open Access
- 20 July 2026
- journal article
- research article
- Published by MDPI AG in Infrastructures
- Vol. 11 (7) , 245
Abstract
In high-strength steel structures, local plate buckling is a critical concern due to the slenderness of plate elements. This study experimentally and numerically investigated the local buckling analysis of Q550 high-strength steel stiffened plates with T-ribs under compression. Five specimens with different base-plate slenderness were fabricated and subjected to uniaxial compression loading tests. The base plate of all specimens exhibited significant local out-of-plane deformation, and the T-ribs experienced varying degrees of in-plane and out-of-plane deformations. The buckling strength of the specimens decreases with increasing base-plate slenderness. The residual stresses and initial geometric imperfections of the high-strength steel stiffened plate were experimentally measured. Finite element (FE) models incorporating the residual stresses and initial geometric imperfections were established to simulate the buckling behavior of the stiffened plates. The FE models were validated against the experimental results and a parametric study was further conducted. The numerical results indicate that both residual stresses and initial geometric imperfections have a moderate influence on the buckling strength. Furthermore, the formulations in several national design codes used to account for local buckling effects were evaluated. The Eurocode provides approximate predictions, while the Chinese code and Japanese code provide conservative estimations.Keywords
Funding Information
- Science and Technology Commission of Shanghai Municipality (23DZ1202305)
This publication has 30 references indexed in Scilit:
- Effect of aspect ratio and geometric defects on the stability performance of U-rib stiffened platesStructures, 2024
- Welded steel I-section columns: Residual stresses, testing, simulation and designEngineering Structures, 2023
- Overall buckling behaviour of Q420–Q960 steel welded H-section axial compression membersEngineering Structures, 2021
- Direct measurements, numerical predictions and simple formula estimations of welding-induced biaxial residual stresses in a full-scale steel stiffened plate structureStructures, 2021
- Constructal Design for the ultimate buckling stress improvement of stiffened plates submitted to uniaxial compressive loadEngineering Structures, 2020
- Flexural buckling behaviour of 690 MPa high strength steel H-section columnsEngineering Structures, 2019
- Experimental study of inelastic buckling strength and stiffness requirements for longitudinally stiffened panelsEngineering Structures, 2009
- Ultimate strength design of stiffened plates under axial compression and bendingMarine Structures, 1993
- The influence of complex initial deflection modes on the behaviour and ultimate strength of rectangular plates in compressionJournal of Constructional Steel Research, 1985
- Effects of localized imperfections on compressive strength of long rectangular platesJournal of Constructional Steel Research, 1984