Experimental failure analysis of bolted joints in moisture‐ and temperature‐induced composite laminates under preload
- 3 February 2009
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 31 (1) , 173-178
Abstract
In this study, an experimental investigation was carried out in a bolted glass fiber‐reinforced laminate under preload moments. The stacking sequence at the composite laminate was chosen as [90°/0°/45°/−30°]s. The preload moments were selected as 2, 4, and 6 Nm, in order to compare the influence of preload moments on failure modes and strengths. Some specimens were subjected to hot pure water at 70°C for 7 days. The bearing strength in this case was measured again under the same preload moments of 2, 4, and 6 Nm. It is found that the bearing strength of the specimen waited in hot water was 5.4% smaller than that of the specimen in dry condition. POLYM. COMPOS., 2010. © 2009 Society of Plastics EngineersKeywords
This publication has 15 references indexed in Scilit:
- Experimental Determination of Bearing Strength in Fiber Reinforced Laminated Composite Bolted Joints under PreloadJournal of Reinforced Plastics and Composites, 2007
- Progressive failure analysis of pin-loaded carbon–epoxy woven composite platesComposites Science and Technology, 2002
- A study of the effects of various geometric parameters on the failure strength of pin-loaded woven-glass-fiber reinforced epoxy laminateComposites Science and Technology, 2001
- Stress and failure analysis of mechanically fastened joints in composite laminatesComposite Structures, 2000
- Bearing failure of composite bolted joints with non-uniform bolt-to-washer clearanceComposites Part A: Applied Science and Manufacturing, 2000
- A Numerical and Experimental Study of Woven Composite Pin-JointsJournal of Composite Materials, 2000
- A Numerical and Experimental Study of Woven Composite Pin-JointsJournal of Composite Materials, 2000
- Moisture and Temperature Induced Degradation in Tensile Properties of Kevlar-Graphite/Epoxy Hybrid CompositesJournal of Reinforced Plastics and Composites, 1991
- The Effect of Pin Load Distribution on the Strength of Pin Loaded Holes in Laminated CompositesJournal of Composite Materials, 1986
- Strength of Mechanically Fastened Composite JointsJournal of Composite Materials, 1982