Application of Different Cylinder Pressure Based Knock Detection Methods in Spark Ignition Engines
Authors:
- 6 May 2002
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The primary objective of this paper is to compare different methods of knock detection based on cylinder pressure data, with special regard to identifying knocking cycles and detecting the onset of knock. These investigations have resulted in the development of a new knock detection method based on high-pass filtered heat release. Different signal characteristics have been considered. The model has been developed on the basis of experimental data for a four-valve production engine, and verified over a wide range of operating conditions. For the purpose of thermodynamic investigations, the new knock detection algorithm allows the determination of the engine operating points that correspond to the knock limit, and their mean crank angle of knock onset. The thermodynamic properties of the end gas at knock onset have been discussed using a zero-dimensional two-zone model. Existing empirical autoignition delay correlations implemented in the heat release model and derived by matching an Arrhenius function to recorded data on autoignition times, have been applied and compared to a modified autoignition model based on the “Franzke Knock Criterion” [1]. The prediction of knocking operation has been compared with measured data.Keywords
This publication has 21 references indexed in Scilit:
- The Volume Acoustic Modes of Spark-Ignited Internal Combustion ChambersSAE International Journal of Advances and Current Practices in Mobility, 1998
- Comparison of Cylinder Pressure Based Knock Detection MethodsSAE International Journal of Advances and Current Practices in Mobility, 1997
- The Detection and Quantification of Knock in Spark Ignition EnginesSAE International Journal of Advances and Current Practices in Mobility, 1993
- Examination of Methods Used to Characterize Engine KnockSAE International Journal of Advances and Current Practices in Mobility, 1992
- Role of Exothermic Centres on Knock Initiation and Knock DamageSAE International Journal of Advances and Current Practices in Mobility, 1990
- Pressure Trace Knock Measurement in a Current S.I. Production EngineSAE International Journal of Advances and Current Practices in Mobility, 1989
- A Knock Anticipating Strategy Basing on the Real-Time Combustion Mode AnalysisSAE International Journal of Advances and Current Practices in Mobility, 1989
- The Knock Severity Index – A Proposal for a Knock Classification MethodSAE International Journal of Advances and Current Practices in Mobility, 1984
- Individual-Cylinder Knock Occurence and Intensity in Multicylinder EnginesSAE International Journal of Advances and Current Practices in Mobility, 1982
- Regime classification of an exothermic reaction with nonuniform initial conditionsCombustion and Flame, 1980