Development of Quality Control Methods for Robust and Reliable Sensor Design
Open Access
- 1 October 2022
- report
- Published by Office of Scientific and Technical Information (OSTI)
Abstract
The successful adoption of additive manufacturing for the rapid prototyping of printed sensors requires the establishment of quantifiable metrics that can interrogate device performance. One measure of performance is the adhesion strength between the substrate and sensor interface, which is critical since the strength of this interface can dictate the accuracy and reliability of the printed sensor. In this work, a non-contact laser-induced spallation technique was used to quantify the adhesion of silver prints on an aluminum alloy substrate. The laser-based method was compared to a standardized pull-off adhesion test, which provided baseline measurements of adhesion strength. The sintering conditions were shown to play an important role in the film-substrate adhesion strength, as well as the cohesion and ductility of the film itself. The methods and results described in this work supports the establishment of process control steps that are necessary for verifying the reliability of printed devices prior to its deployment in critical experiments.Keywords
This publication has 29 references indexed in Scilit:
- Additively manufactured strain sensors for in-pile applicationsSensors and Actuators A: Physical, 2022
- Aerosol jet printed capacitive strain gauge for soft structural materialsnpj Flexible Electronics, 2020
- Flexible and Stretchable Electronics for Harsh‐Environmental ApplicationsAdvanced Materials Technologies, 2019
- A fundamental study of printed ink resiliency for harsh mechanical and thermal environmental applicationsAdditive Manufacturing, 2018
- Experimental and statistical study of three adherence tests for an epoxy-amine/aluminum alloy system: Pull-Off, Single Lap Joint and Three-Point Bending testsInternational Journal of Adhesion and Adhesives, 2017
- Properties and long-term behavior of nanoparticle based inkjet printed strain gaugesJournal of Materials Science: Materials in Electronics, 2016
- A review of irradiation effects on LWR core internal materials – Neutron embrittlementJournal of Nuclear Materials, 2011
- An overview of the potential of quantitative coating adhesion measurement by scratch testingTribology International, 2006
- Effect of film thickness on the stress and adhesion of diamond-like carbon coatingsDiamond and Related Materials, 2002
- A parametric study of laser induced thin film spallationExperimental Mechanics, 2002