Buck DC-AC converter using gallium-nitride FETs for amplitude-modulated class-E RF power amplifiers
- 1 November 2015
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 003579-003584
Abstract
This paper presents the analysis and design of the pulse-width modulated (PWM) buck dc-ac converter used as a dynamic power supply for amplitude-modulated class-E radio-frequency (RF) power amplifier (PA). The buck dc-ac converter operates at a fixed input voltage and a variable output voltage. The differences in the inductor current profiles of the buck dc-ac converter and the classical buck dc-dc converter are highlighted. The design equations required to estimate the minimum value of the inductance of the buck dc-ac converter in continuous-conduction mode and consequently, the minimum value of capacitance are derived. A suitable design example is presented for the buck dc-ac converter operating at a fixed input voltage VI = 14 V, a variable output voltage 2 V ≤ VDD ≤ 12 V, switching frequency fs = 100 kHz and supplying power to a class-E RFPA with a maximum output power PO = 10 W and a carrier frequency fc = 1 MHz. Simulations are performed for the buck dc-ac converter and class-E RFPA comprising of gallium-nitride (GaN) field-effect transistors. In this paper, the anti-parallel diode of the GaN transistor is used as the freewheeling diode in the buck converter. Finally, few concluding remarks discussing the effectiveness of the buck converter as an amplitude-modulator is presented.Keywords
This publication has 19 references indexed in Scilit:
- High-Frequency PWM Buck Converters Using GaN-on-SiC HEMTsIEEE Transactions on Power Electronics, 2014
- Analysis of Dynamic and Transient Response of Frequency Modulated Class E AmplifierIEICE Transactions on Communications, 2014
- A Two-Phase Switching Hybrid Supply Modulator for RF Power Amplifiers With 9% Efficiency ImprovementIEEE Journal of Solid-State Circuits, 2010
- Ultrafast Tracking Power Supply With Fourth-Order Output Filter and Fixed-Frequency Hysteretic ControlIEEE Transactions on Power Electronics, 2008
- Off-Nominal Operation of Class-E Amplifier at Any Duty RatioIEEE Transactions on Circuits and Systems I: Regular Papers, 2007
- Design procedure of class-E amplifier for off-nominal operation at 50% duty ratioIEEE Transactions on Circuits and Systems I: Regular Papers, 2006
- Analysis of sub-optimum operation of class E amplifier2006
- Steady-State Behavior of Class E Amplifier Outside Designed Conditions2005
- High-efficiency power amplifier using dynamic power-supply voltage for CDMA applicationsIEEE Transactions on Microwave Theory and Techniques, 1999
- Collector amplitude modulation of the class E tuned power amplifierIEEE Transactions on Circuits and Systems, 1984