Tadashi Suetsugu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tadashi Suetsugu has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Marian Kazimierz Kazimierczuk
Department of Electrical Engineering, Wright State University, Dayton, OH 45435, USA
3 shared publications Adi Riyadahi
1 shared publication- Agasthya Ayachit
Department of Electrical Engineering Wright State University Dayton Ohio 45435 USA
1 shared publication - Agus Salim
Faculty of Science and Technology, Syarif Hidayatullah State Islamic University (UIN) Jakarta
1 shared publication - Dalvir K. Saini
Department of Electrical Engineering, Wright State University, Dayton, OH, USA
1 shared publication Hideaki Orii
1 shared publication
Latest Publications
- Open Access
- 30 September 2016
- Published by Universiti Teknologi PETRONAS in International Journal of Biomass and Renewables
- Vol. 5 (2) , 23
Extraction of Isovitexin from Melinjo (Gnetum Gnemon L.) Leaves Using Mixtures of Liquid Carbon Dioxide and Ethanol
- 30 September 2016
- Published by Universiti Teknologi PETRONAS in International Journal of Biomass and Renewables
- Vol. 5 (2) , 23
Open AccessExtraction of Isovitexin from Melinjo (Gnetum Gnemon L.) Leaves Using Mixtures of Liquid Carbon Dioxide and Ethanol
- 1 November 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 003579-003584
Buck DC-AC converter using gallium-nitride FETs for amplitude-modulated class-E RF power amplifiers
This paper presents the analysis and design of the pulse-width modulated (PWM) buck dc-ac converter used as a dynamic power supply for amplitude-modulated class-E radio-frequency (RF) power amplifier (PA). The buck dc-ac converter operates at a fixed input voltage and a variable output voltage. The differences in the inductor current profiles of the buck dc-ac converter and the classical buck dc-dc converter are highlighted. The design equations required to estimate the minimum value of the inductance of the buck dc-ac converter in continuous-conduction mode and consequently, the minimum value of capacitance are derived. A suitable design example is presented for the buck dc-ac converter operating at a fixed input voltage VI = 14 V, a variable output voltage 2 V ≤ VDD ≤ 12 V, switching frequency fs = 100 kHz and supplying power to a class-E RFPA with a maximum output power PO = 10 W and a carrier frequency fc = 1 MHz. Simulations are performed for the buck dc-ac converter and class-E RFPA comprising of gallium-nitride (GaN) field-effect transistors. In this paper, the anti-parallel diode of the GaN transistor is used as the freewheeling diode in the buck converter. Finally, few concluding remarks discussing the effectiveness of the buck converter as an amplitude-modulator is presented.
- 1 November 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 003579-003584
Buck DC-AC converter using gallium-nitride FETs for amplitude-modulated class-E RF power amplifiers
This paper presents the analysis and design of the pulse-width modulated (PWM) buck dc-ac converter used as a dynamic power supply for amplitude-modulated class-E radio-frequency (RF) power amplifier (PA). The buck dc-ac converter operates at a fixed input voltage and a variable output voltage. The differences in the inductor current profiles of the buck dc-ac converter and the classical buck dc-dc converter are highlighted. The design equations required to estimate the minimum value of the inductance of the buck dc-ac converter in continuous-conduction mode and consequently, the minimum value of capacitance are derived. A suitable design example is presented for the buck dc-ac converter operating at a fixed input voltage VI = 14 V, a variable output voltage 2 V ≤ VDD ≤ 12 V, switching frequency fs = 100 kHz and supplying power to a class-E RFPA with a maximum output power PO = 10 W and a carrier frequency fc = 1 MHz. Simulations are performed for the buck dc-ac converter and class-E RFPA comprising of gallium-nitride (GaN) field-effect transistors. In this paper, the anti-parallel diode of the GaN transistor is used as the freewheeling diode in the buck converter. Finally, few concluding remarks discussing the effectiveness of the buck converter as an amplitude-modulator is presented.
- 1 November 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 1553572X,p. 1318-1322
Diode peak voltage clamping of class E amplifier
In this paper, a diode clamp circuit, which reduces the transient peak switch voltage of the class E amplifier, is proposed. This clamp circuit clamps the output voltage of the class E amplifier when the amplitude of output voltage becomes much larger than the designed value. Such a situation happens when the load resistance is open-circuited. A rough estimation of the amplitude of the output current when output voltage is clamped is described. Experimental results showed that the proposed diode clamp circuit successfully reduces the transient peak switch voltage.
- 1 November 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 1553572X,p. 1318-1322
Diode peak voltage clamping of class E amplifier
In this paper, a diode clamp circuit, which reduces the transient peak switch voltage of the class E amplifier, is proposed. This clamp circuit clamps the output voltage of the class E amplifier when the amplitude of output voltage becomes much larger than the designed value. Such a situation happens when the load resistance is open-circuited. A rough estimation of the amplitude of the output current when output voltage is clamped is described. Experimental results showed that the proposed diode clamp circuit successfully reduces the transient peak switch voltage.
- 22 September 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 4
Operation of class DE amplifier outside optimum condition
- 22 September 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 4
Operation of class DE amplifier outside optimum condition
- 25 June 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 4
Voltage-clamped class E amplifier with a Zener diode across the switch
- 25 June 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 4
Voltage-clamped class E amplifier with a Zener diode across the switch
- 22 November 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 544-549
Resonant DC/DC converter using Class DE oscillator
A new resonant DC/DC converter with Class DE oscillator is introduced, along with its analysis and experimental results. It consists of a Class DE power oscillator and a Class D transformer center-tapped rectifier. The Class DE oscillator ensures a low peak voltage across switches and can be smaller than a conventional one because the Class DE oscillator does not need an additional circuit to drive MOSFETs. The Class D rectifier offers low switching losses and noise. The measured efficiency was over 80% at 2 MHz and 2.5 W.
- 22 November 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 544-549
Resonant DC/DC converter using Class DE oscillator
A new resonant DC/DC converter with Class DE oscillator is introduced, along with its analysis and experimental results. It consists of a Class DE power oscillator and a Class D transformer center-tapped rectifier. The Class DE oscillator ensures a low peak voltage across switches and can be smaller than a conventional one because the Class DE oscillator does not need an additional circuit to drive MOSFETs. The Class D rectifier offers low switching losses and noise. The measured efficiency was over 80% at 2 MHz and 2.5 W.