Effects of Silicon and Aluminum Alloying on Phase Transformation and Microstructure Evolution in Fe–0.2C–2.5Mn Steel: Insights from Continuous–Cooling–Transformation and Time–Temperature–Transformation Diagrams
Open Access
- 25 August 2024
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 95 (12)
Abstract
The impact of silicon and aluminum on phase transformation behavior, particularly bainite, and microstructure evolution in Fe–0.2C–2.5Mn steel are presented. Continuous–cooling–transformation (CCT) and time–temperature–transformation (TTT) diagrams are determined experimentally. An aluminum extended empirical formula is introduced to estimate the martensite start temperature (Ms) with a thorough assessment of existing formulae. Results show that aluminum significantly increases Ms and has a stronger influence on promoting ferritic microstructures than silicon. During continuous cooling, alongside bainite, formation of Widmanstätten structures is induced in aluminum‐alloyed steel at higher cooling rates due to increased prior austenite grain size. Silicon decelerates bainite transformation kinetics by enhancing austenite's chemical stability through carbon enrichment via preventing carbide precipitation and by strengthening austenite against displacive phase transformation via solid solution hardening. Although aluminum has similar effects, incubation time is shortened during isothermal treatment because of the increased driving force, which overcompensates for the retardation effects. A finer carbide‐free bainitic microstructure is achieved in aluminum‐alloyed steel with more pronounced film‐like retained austenite (RA) formation and superior carbon enrichment, improving RA stability and suppressing martensite–austenite island formation. Finally, with the proposed formula, an accurate approximation to experimental Ms is accomplished.Keywords
This publication has 44 references indexed in Scilit:
- Influence of Transformation Temperature on the High‐Cycle Fatigue Performance of Carbide‐Bearing and Carbide‐Free BainiteSteel Research International, 2023
- Air Cooling Martensites—The Future of Carbon Neutral Steel Forgings?Advanced Engineering Materials, 2023
- Effect of prior martensite formation on the bainite transformation kinetics in high-strength 3% Mn multiphase steelJournal of Thermal Analysis and Calorimetry, 2022
- Transformation Behavior and Properties of Carbide‐Free Bainite Steels with Different Si ContentsSteel Research International, 2018
- Influence of Heat Treatment on Microstructure Stability and Mechanical Properties of a Carbide‐Free Bainitic SteelAdvanced Engineering Materials, 2017
- Austenitic Grain Growth Behavior during Austenization in an Aluminum-Alloyed 5% Cr-Mo-V SteelSteel Research International, 2016
- Extension of the Martensite Transformation Temperature Relation to Larger Alloying Elements and ContentsAdvanced Engineering Materials, 2013
- Relative Influences of Aluminium and Silicon on the Kinetics of Bainite Formation from Intercritical AusteniteSteel Research International, 2008
- An examination of the validity of existing empirical formulae for the calculation of ms temperatureMetallurgical Transactions A, 1982
- Application of hardenability concepts in heat treatment of steelJournal of Heat Treating, 1979