On shear fracture and morphological features of fused filament fabrication based almond skin reinforced PLA structures
- 4 September 2021
- journal article
- research article
- Published by Taylor & Francis in Advances in Materials and Processing Technologies
- Vol. 8 (3) , 3553-3581
Abstract
The polylactic acid (PLA) composite-based 3D printed functional prototypes have been widely explored for preparation of biomedical scaffolds with fused filament fabrication (FFF). But hitherto little has been reported on the use of the almond skin (AS) as reinforcement in PLA matrix for scaffolding applications with improved shear modulus (SM). In this study composite of PLA and AS was subjected to pull-out test to ensure SM and modulus of toughness (MOT), surface hardness and morphological investigations for use as scaffold. The results of study show that during pull-out test, maximum shear strength at peak (PSS) as 22.85MPa; maximum shear strength at break (BSS) as 20.56MPa was observed for samples printed with infill density (ID) 100%, infill angle (IA) 45° and infill speed (IS) 90 mm/s (on open source FFF setup). The maximum MOT as 25.50 MPa was noticed for sample printed at ID 60%, IA 45° and IS 50 mm/s. Further maximum SM as 21.80 MPa was observed for samples printed at ID 60%, IA 60° and IS 70 mm/s. The results have been supported by photo-micrographic analysis; surface hardness analysis; Taguchi and response surface methodology based historical data approach for optimisation of pull-out properties.Keywords
This publication has 29 references indexed in Scilit:
- Improvement on the properties of polylactic acid (PLA) using bamboo charcoal particlesComposites Part B: Engineering, 2015
- Variability of the pullout strength of cancellous bone screws with cement augmentationClinical Biomechanics, 2015
- Axial pullout strength comparison of different screw designs: fenestrated screw, dual outer diameter screw and standard pedicle screwScoliosis, 2015
- The uplift load capacity of an enlarged base pier embedded in dry sandArabian Journal of Geosciences, 2014
- Special materials used in FDM rapid prototyping technology application2012
- Processing Stability and Biodegradation of Polylactic Acid (PLA) Composites Reinforced with Cotton Linters or Maple Hardwood FibresJournal of Polymers and the Environment, 2012
- Screw pullout behaviour in polyethyleneMaterials & Design (1980-2015), 2007
- Analysis of carbon nanotube pull-out from a polymer matrixSurface Science, 2003
- Wood‐flour‐reinforced polyethylene: Viscoelastic behavior and threaded fastenersPolymer Engineering & Science, 2002
- Pullout Bond Properties of Fiber-Reinforced Polymer Tendons to GroutJournal of Materials in Civil Engineering, 2002