Numerical and In Vitro Investigations of Pressure Rise in a New Hydrodynamic Blood Bearing
Authors:
- 25 April 2007
- journal article
- Published by Wiley in Artificial Organs
- Vol. 31 (6) , 434-440
Abstract
Abstract: The reliability and simplicity of rotor bearing are vital to the success of long‐term implantation of rotary blood pumps. This article describes both numerical and in vitro studies of the pressure rise in a 5‐cm‐diameter spiral groove bearing. Results show that the simplified analytical model overpredicts the pressure rise across the bearing while the results from a more comprehensive three‐dimensional computational fluid dynamics (CFD) model agree well with the measurements. The discrepancy between the analytical model and the measurements is attributed to the exclusion of the fluid inertia effects in the analytical model. In addition, the assumption of linear pressure variations at the entrance of the groove and the ridge may have oversimplified the analysis. CFD results show that the pressure variation at the entrance of the groove and ridge is nonlinear. A correction factor taking into consideration the fluid inertia effect has been incorporated, and the modified analytical results agreed well with the measurement as well as that of the more comprehensive CFD model. The pressure generated is sufficient to lift the rotor, and this design provides the designer an alternative design for passive bearing.Keywords
This publication has 11 references indexed in Scilit:
- Concept for a New Hydrodynamic Blood Bearing for Miniature Blood PumpsArtificial Organs, 2004
- Analytical investigation of leakage flow in disk clearance of a magnetically suspended centrifugal impeller.Artificial Organs, 2000
- Sealing Properties of Mechanical Seals for an Axial Flow Blood PumpArtificial Organs, 1999
- A Sealless Centrifugal Blood Pump with Passive Magnetic and Hydrodynamic BearingsArtificial Organs, 1999
- Design Considerations for Bearingless Rotary PumpsArtificial Organs, 1997
- The Optimum Groove Geometry for Spiral Groove Viscous PumpsJournal of Tribology, 1990
- Performance of Water-Lubricated Flat Spiral Groove BearingsJournal of Tribology, 1985
- On the Possibilities of Improving the Accuracy of the Evaluation of Inertia Forces in Laminar and Turbulent FilmsJournal of Lubrication Technology, 1974
- Analytical Investigation of the Spiral Groove Face SealJournal of Lubrication Technology, 1973
- Analysis and Design of Spiral-Groove BearingsJournal of Lubrication Technology, 1967