Workability Limit Diagram at Plane Stress Condition
Open Access
- 18 December 2025
- journal article
- Published by Faculty of Technical Sciences in Advanced Technologies & Materials
- Vol. 50 (2) , 17-24
Abstract
Numerous experimental studies of workability limit diagrams in the domain of bulk deformation have been performed on specimens where failure occurs at the free surface, i.e., under plane stress conditions. Previous investigations of workability diagrams using compression tests on axially symmetric specimens have yielded negative values of the stress triaxiality ratio (β < –1), while positive values have predominantly been obtained from tensile tests, often exceeding β > +3. The objective of the present study is to explore the applicability of additional deformation models under plane stress conditions that could extend the workability diagram into regions corresponding to negative stress triaxiality ratio values. Additionally, the study aims to determine the limiting values of the stress triaxiality ratio under such stress conditions. For cold bulk forming processes, the region of the workability diagram associated with negative stress triaxiality ratio values (β < –1) is of particular technological importance. The analysis of various formability tests under plane stress conditions was conducted using idealized deformation models, in which the deformation path was assumed to be linear.Keywords
This publication has 23 references indexed in Scilit:
- A Ductile Fracture Criterion of Ti-6Al-4V at Room TemperatureExperimental Mechanics, 2016
- An Improved Experimental Method for Determining the Workability DiagramExperimental Mechanics, 2012
- Experimental Study of the Effect of Triaxiality Ratio on the Formability Limit Diagram and Ductile Damage Evolution in Steel and High Purity CopperInternational Journal of Material Forming, 2010
- A study on an effect of geometric singularities on ductile fractureEngineering Fracture Mechanics, 2009
- Fracture of austenitic steel subject to a wide range of stress triaxiality ratios and crack deformation modesEngineering Fracture Mechanics, 2008
- An approach to predict free surface fracture in bulk formingMetallurgical and Materials Transactions A, 2006
- Free Surface Fracture in Three Upsetting TestsExperimental Mechanics, 2006
- Fracture in formingJournal of Materials Processing Technology, 1996
- An empirical formula for workability limits in cold upsetting and bolt headingJournal of Applied Metalworking, 1986
- The cold upsetting and free surface ductility of some commercial steelsJournal of Applied Metalworking, 1984