Comparison of Pavement Roughness Indicators from Traditional Inertial Profilers and Emerging Connected Vehicle Sensors
Open Access
- 31 May 2026
- journal article
- research article
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
Abstract
This study is an evaluation of the consistency and potential of crowdsourced connected vehicle (CV) data as an alternative to traditional inertial profiler (IP) measurements for road roughness evaluation. IP data were collected from three roadway corridors, SH 21, SH 6, and FM 2818, in Bryan, Texas, which comprised a variety of pavement types and functional classifications. Lane-specific international roughness index (IRI) values were recorded using a calibrated inertial profiler and analyzed at every 10 ft. These were compared with direction level ride values collected at an average spacing of 82 ft from a third-party CV data provider. A general agreement was found between IP and CV data on asphalt and concrete surfaces, but there were substantial differences between seal coat sections, where CV ride values overestimated roughness by 80–100 in./mi. A grouping analysis was conducted to compare segments categorized by roughness level from both datasets. The results showed a moderate match in identifying the roughest segments by the CV system, compared with those identified by IP. This match rate varied by profile and improved with broader grouping sizes. Results show that CV data might have greater sensitivity to vehicle behavior (for example, braking at intersections), while IP-based systems are calibrated to record actual road roughness. This could be one of the reasons for the moderate mismatch in identifying rougher segments using the two methods. Despite these limitations, the CV system’s high frequency of measurements, especially on highways, demonstrates its potential for cost-effective, network-level pavement monitoring.Keywords
Funding Information
- Strategic Initiatives and Innovation Division of the Texas Department of Transportation
This publication has 11 references indexed in Scilit:
- Differences Evaluation of Pavement Roughness Distribution Based on Light Detection and Ranging DataApplied Sciences, 2023
- Deep learning for estimating pavement roughness using synthetic aperture radar dataAutomation in Construction, 2022
- Deep learning-based road damage detection and classification for multiple countriesAutomation in Construction, 2021
- Development of a Deep Convolutional Neural Network for the Prediction of Pavement Roughness from 3D ImagesJournal of Transportation Engineering, Part B: Pavements, 2021
- Validation of a Low-Cost Pavement Monitoring Inertial-Based System for Urban Road NetworksSensors, 2021
- Large-scale pavement roughness measurements with vehicle crowdsourced data using semi-supervised learningTransportation Research Part C: Emerging Technologies, 2021
- Development of a crowdsourcing-based system for computing the international roughness indexInternational Journal of Pavement Engineering, 2020
- Evaluation of Audible Lane Departure Warning Treatments on Seal CoatsTransportation Research Record: Journal of the Transportation Research Board, 2019
- Estimation of Pavement Serviceability Index Through Android-Based Smartphone Application for Local RoadsTransportation Research Record: Journal of the Transportation Research Board, 2017
- Connected Vehicle Approach for Pavement Roughness EvaluationJournal of Infrastructure Systems, 2014