An HMM Generator With Low Load Dependency for Alternative TLP-HMM
- 5 May 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 67 (4) , 1052-1063
Abstract
Various types of transmission line pulse-human metal models (TLP-HMM) have been proposed as alternatives to electrostatic discharge (ESD) generators for immunity testing of devices because TLP-HMM generates more stable discharge current waveforms than ESD generators. The output impedance of TLP-HMM differs from that of ESD generators due to their distinct discharge mechanisms. Therefore, we focused on an HMM generator via a coaxial cable that generates discharges using RC circuits, similar to ESD generators. However, ESD generators and the HMM generator differ in terms of their output structure and calibration target. This may cause the discharge current waveforms to vary when used on a device under test (DUT). In this study, the problems caused by the differences in the output structure and calibration target were identified through equivalent circuit modeling of the HMM generator corresponding to the discharge waveform measurement of two loads in simulating DUT. Subsequently, a low load dependency-human metal model (LLD-HMM) is proposed by addressing the problems to generate same-shaped discharge current waveforms for arbitrary resistive and certain capacitive loads with arbitrary cable lengths. The effectiveness of the LLD-HMM was verified through simulations and experiments.Keywords
Funding Information
- JST SPRING (JPMJSP2112)
This publication has 21 references indexed in Scilit:
- Influence of Return Current Cable Arrangement on Ringing Damped Oscillations in Contact Discharge Calibration Waveform from ESD Generator2023
- Improvement of TLP-HMM’s Load Dependence2023
- Measurement of Current Waveform Due to Different Load of ESD Gun, TLP-HMM, and CR-HMM2022
- Investigation of the frequency response compensation method for ESD current reconstruction for different test levels and ESD test generators2020
- From quasi-static to transient system level ESD simulation: Extraction of turn-on elements2016
- System-level ESD failure analysis depending on source generators2016
- TLP-based Human Metal Model stress generator and analysis method of ESD generators2015
- Behavioral ESD protection modeling to perform system level ESD efficient design2012
- A TLP-based Human Metal Model ESD-generator for device qualification according to IEC 61000-4-22010
- A circuit approach to simulate discharge current injected in contact with an ESD-gun2003